How Much Play Should A Distributor Rotor Have at Annie Leavens blog

How Much Play Should A Distributor Rotor Have. Ideally, there should be no vertical play, and the distributor shaft should move up and down in sync with the engine’s rotation. This one might be considered too much rotational play. It's a lot easier to pull the distributor and replace a worn gear than it is to replace the camshaft, so the distributor gear should always. The balancer is 6 diameter so that's roughly 10 degrees. How much play should there be in the rotor inside my distributor? The side play is more critical, as that will alter the points opening and. Shoot me.but i don't have. Should i be able to rotate it by hand a few degrees and if so how. The only way to get the right rotor was by getting a smaller kit with just points, condenser and rotor. There can only be slop/play in the distributor gear and/or timing chain that. I narrowed it down to the distributor based on a lot of up/down play in the original, and i assumed gear wear, which gave me what.

There can only be slop/play in the distributor gear and/or timing chain that. How much play should there be in the rotor inside my distributor? The only way to get the right rotor was by getting a smaller kit with just points, condenser and rotor. Should i be able to rotate it by hand a few degrees and if so how. This one might be considered too much rotational play. The balancer is 6 diameter so that's roughly 10 degrees. Ideally, there should be no vertical play, and the distributor shaft should move up and down in sync with the engine’s rotation. It's a lot easier to pull the distributor and replace a worn gear than it is to replace the camshaft, so the distributor gear should always. I narrowed it down to the distributor based on a lot of up/down play in the original, and i assumed gear wear, which gave me what. The side play is more critical, as that will alter the points opening and.

Bad Distributor Cap Symptoms, Testing, Replacement Cost In The

How Much Play Should A Distributor Rotor Have The only way to get the right rotor was by getting a smaller kit with just points, condenser and rotor. The only way to get the right rotor was by getting a smaller kit with just points, condenser and rotor. The balancer is 6 diameter so that's roughly 10 degrees. This one might be considered too much rotational play. There can only be slop/play in the distributor gear and/or timing chain that. It's a lot easier to pull the distributor and replace a worn gear than it is to replace the camshaft, so the distributor gear should always. Should i be able to rotate it by hand a few degrees and if so how. Shoot me.but i don't have. Ideally, there should be no vertical play, and the distributor shaft should move up and down in sync with the engine’s rotation. The side play is more critical, as that will alter the points opening and. How much play should there be in the rotor inside my distributor? I narrowed it down to the distributor based on a lot of up/down play in the original, and i assumed gear wear, which gave me what.