Lectron Carb Problems at Ronald Roe blog

Lectron Carb Problems. The needle seat valve controls all of the fuel flow into your carburetor. The moment i put it in it ran lean with a 5. Our two stroke carbs need a gap of 5/64 (2mm) which is about 4.25 turns form all the way in on the idle screw on billetron 38/38 pro models,. So i bought a lectron carb in 2019 for my 2001 ktm 380 exc and it has never worked right. When i ran it on the 450, the problem was always too rich an idle/low end and if i added air. Looks like the gen 2 might be mixing air and fuel? If it is not filling, a sharp tap on the float bowl support bracket can help. I have a lectron carb on it and starts and runs just fine while it is warming up, then once. I have a 2020 yz250 with a 295 big bore kit. When i got the carb, my throttle cable was too short (no surprise) and the throttle cable i bought didn't fit my bike without having. On my carb, it just adds air at idle.

Looks like the gen 2 might be mixing air and fuel? On my carb, it just adds air at idle. If it is not filling, a sharp tap on the float bowl support bracket can help. When i ran it on the 450, the problem was always too rich an idle/low end and if i added air. The needle seat valve controls all of the fuel flow into your carburetor. So i bought a lectron carb in 2019 for my 2001 ktm 380 exc and it has never worked right. I have a lectron carb on it and starts and runs just fine while it is warming up, then once. The moment i put it in it ran lean with a 5. I have a 2020 yz250 with a 295 big bore kit. When i got the carb, my throttle cable was too short (no surprise) and the throttle cable i bought didn't fit my bike without having.

Help identifying Lectron carb Motorcycle Jetting & Fuel Injection

Lectron Carb Problems I have a lectron carb on it and starts and runs just fine while it is warming up, then once. On my carb, it just adds air at idle. Looks like the gen 2 might be mixing air and fuel? If it is not filling, a sharp tap on the float bowl support bracket can help. I have a lectron carb on it and starts and runs just fine while it is warming up, then once. Our two stroke carbs need a gap of 5/64 (2mm) which is about 4.25 turns form all the way in on the idle screw on billetron 38/38 pro models,. The moment i put it in it ran lean with a 5. So i bought a lectron carb in 2019 for my 2001 ktm 380 exc and it has never worked right. I have a 2020 yz250 with a 295 big bore kit. The needle seat valve controls all of the fuel flow into your carburetor. When i ran it on the 450, the problem was always too rich an idle/low end and if i added air. When i got the carb, my throttle cable was too short (no surprise) and the throttle cable i bought didn't fit my bike without having.