P Trap Not Long Enough

If the p-trap will not swing enough to align with the tail piece, you will need to provide an offset on the vertical. I would do this by changing the p-trap to a hub connection type (should be able to reuse the existing union 90) and then hard pipe up from the p-trap, installing two 45 elbows on the vertical and then connecting to the tail. The 1¼" tailpiece from your drain assembly (the piece which is screwed in, with the teflon tape-GOOD!-) is the standard 4" long piece which is provided with your unit.

6" and 12" long tailpieces are availabel at any supplier or box store. Another reason why your P-trap may not hold water is due to lack of use or dry weather. If a plumbing fixture connected to the P-trap is not used frequently, the water in the trap can evaporate over time.

When the bathroom or kitchen drain drop tube is not long enough, you can use a drain extension tube. Makes lining up the p trap with the drain connection a p. We just got a new vanity and installed it and noticed that on sink 2 the ptrap isnt long enough to reach the drain.

Is there some kind of configuration that will allow me to reach sink#2 without cutting the drain pipe at the wall? But running tap water seems to drain ok. I suspect the P-Trap isn't correct or not installed properly? Please see attached photo.

I've never seen a sharp P-Trap like this for kitchen sink and is it too long or wide enough? Or I need to clear the drain line or check the vent on the roof? What do you suggest? Thank you! Reasons a P-trap Doesn't Line up with Drain Three main reasons cause the p. Let's dive into the most common P-trap problems and how to troubleshoot them with confidence.

We'll explore each issue in detail, unpack why it happens, and arm you with practical solutions. Consider this your ultimate guide to tackling P. How To Raise A P-Trap That Is Lower Than The Drain Pipe The simplest way to fix a P-trap that is lower than the drain line is by raising it.

The process is easy enough to complete by beginners. What You'll Need Hacksaw Pliers New tailpiece (optional) P-trap Sandpaper Plumber's putty Tape measure Marker 1. Measure The P-Trap Height To raise the P-trap and align it with the wall stub, you.

The alignment between that and the drain coming from the sink doesn't have enough space for a p-trap to be installed so it just falls into place and connects the two (prior to remodel there was no p-trap).