Ever found yourself in a situation where you've had to remove your bathroom sink's plumbing for repairs or updates, only to be left wondering how to put it all back together? Fear not, as we've created this comprehensive guide to walk you through the process step by step. By the end of this article, you'll have your bathroom sink plumbing back in place and functioning perfectly.
Gather Your Tools and Materials
Before you begin, ensure you have all the necessary tools and materials at hand. This will save you time and prevent any potential frustration. Here's a list of what you'll need:
- Adjustable wrench
- Plumber's putty
- Teflon tape
- New drain assembly (if required)
- Screwdriver (Philips or flathead, depending on your sink's hardware)
- Plastic basin wrench (optional, but helpful for reaching tight spaces)
Reassemble the Drain Assembly
The drain assembly is the crucial component that connects your sink to the drain pipe. If you've replaced it, follow the manufacturer's instructions to assemble it. If not, you can reuse the old one. Here's how to prepare it:

- Wrap the threads of the P-trap and the tailpiece with Teflon tape to create a watertight seal.
- Apply a small amount of plumber's putty around the base of the drain flange.
Install the Drain Flange
Now that your drain assembly is prepared, it's time to install the drain flange. This is the part that sits on top of the sink and connects to the drain assembly from below. Here's how to do it:
- Place the drain flange into the hole in your sink.
- Secure it in place by screwing the nut onto the threaded part of the drain assembly from below. Tighten it by hand until it's snug, then use an adjustable wrench to give it a final turn.
- Wipe away any excess plumber's putty.
Connect the P-Trap
The P-trap is the curved section of pipe that connects the tailpiece to the drain pipe. It's designed to trap water and prevent sewer gases from entering your home. Here's how to connect it:
- Apply a small amount of Teflon tape to the threads of the P-trap.
- Screw the P-trap onto the tailpiece by hand, turning it clockwise. Tighten it with an adjustable wrench, but be careful not to overtighten as this can cause the P-trap to leak.
Connect the Drain Pipe
Now it's time to connect the P-trap to the drain pipe. This will vary depending on your plumbing setup, so consult your local building codes if you're unsure. Here's a general guide:

- Apply a small amount of Teflon tape to the threads of the P-trap and the drain pipe.
- Screw the P-trap onto the drain pipe by hand, turning it clockwise. Tighten it with an adjustable wrench, but again, be careful not to overtighten.
Test Your Work
Before you declare the job done, it's essential to test your work. Here's how:
- Fill your sink with water and let it drain. The water should drain quickly and without any leaks.
- Check underneath the sink for any signs of leaks. If there are no leaks, you've successfully reassembled your bathroom sink plumbing!
Remember, if at any point you're unsure about a step or encounter a problem, don't hesitate to call a professional plumber. It's always better to be safe than sorry when it comes to plumbing. Happy DIY-ing!