Replacing basement windows in a concrete block foundation is one of the most effective ways to refresh your underground space, improve natural light, and enhance energy efficiency. Unlike wood-framed openings, concrete block requires specific materials and techniques to ensure a waterproof and structurally sound installation. This guide breaks down the process into clear, actionable steps for homeowners and DIY enthusiasts.
Assessing Your Current Window Installation
Before removing the old unit, you must evaluate the condition of the existing setup. Many basement windows, often called "well windows" or "crawl windows," are set into a concrete pocket rather than being framed with wood. Determine if the surrounding concrete is solid or if there are signs of spalling, cracking, or persistent moisture. If major structural issues are present, consulting a structural engineer is recommended before proceeding with the replacement.
Gathering the Right Tools and Materials
Success in this project hinges on having the correct equipment. You will need a reciprocating saw with a masonry blade, a heavy-duty reciprocating saw, or a rotary hammer with a chisel for cutting through concrete. Personal protective equipment, including safety glasses, gloves, and a dust mask, is essential. For the new window, you should source a high-quality vinyl or aluminum window designed for below-grade applications, along with a flexible, water-resistant flashing kit and hydraulic cement for sealing.

Essential Tool Checklist
- Reciprocating saw or rotary hammer
- Masonry blade or chisel set
- Safety glasses and work gloves
- Measuring tape and level
- Hydraulic cement and bonding adhesive
- New window unit (vinyl or aluminum)
Removing the Old Window Unit
Begin by clearing out any old mortar or debris from the joint lines. Using your saw or chisel, carefully cut through the mortar surrounding the window jamb. Work methodically to avoid damaging the surrounding block. Once the mortar is compromised, gently wiggle the window frame to loosen it. Exercise caution, as the concrete edges can be sharp. Remove the entire frame and clean the cavity thoroughly to ensure a solid substrate for the new installation.
Measuring and Preparing the New Window
Accuracy is critical when measuring the new window opening. Measure the height and width of the cavity from edge to edge, subtracting 1/4 inch from both dimensions to allow for adjustment and flashing. If the new window comes with a nailing flange, verify that it will sit flush against the concrete block. Apply a bead of construction adhesive to the back of the window frame if the manufacturer recommends it, which helps prevent air infiltration behind the unit.
Installing the New Window with Flashing
Place the new window into the cavity, ensuring it is level and plumb. Insert shims made of PVC or fiber cement between the frame and the concrete to stabilize the unit. It is crucial to maintain a consistent drainage plane; the window must be installed slightly tilted inward to encourage water to flow downward. Wrap the perimeter with the flashing kit, sealing all joints with hydraulic cement to create a waterproof barrier that prevents groundwater from seeping into the basement.

Finishing the Installation
After the mortar has cured and the flashing is secure, apply a high-quality exterior caulk around the edges where the window meets the foundation wall. This final step seals against air leaks and minor water penetration. Allow the adhesive and sealants to dry completely before finishing the interior trim. Once the drywall or framing is restored, your basement window will look like new, providing years of clear views and natural light.




















![HOW TO Replace A Basement Window. [Part ONE]](https://i.pinimg.com/originals/a3/95/50/a39550d743e948097a79d976b886ff0c.jpg)


