Removing a single-handle Moen kitchen faucet might seem like a job for a professional, but with the right guidance, it is a straightforward task you can complete in under an hour. This guide walks you through the exact steps to safely disconnect the fixture without damaging your sink or the faucet components.
Gather Your Tools and Prepare the Area
Before you begin, ensuring you have the right tools prevents mid-project frustration. You will need an adjustable wrench, a basin wrench, a screwdriver set (including a Phillips and a flat-head), and potentially a hex key set if your model uses hex screws. Placing a rag or a piece of cardboard in the bottom of the sink is a simple but crucial step; it protects the porcelain from scratches and provides traction for the parts as you loosen them.
Shut Off the Water Supply
Locate the two shut-off valves under the sink, one for the hot line and one for the cold line. Turn the valves clockwise tightly to stop the water flow. To verify that the water is truly off, turn the faucet handle on the sink on and let it run for a few seconds; if no water comes out, you have successfully isolated the fixture. If you do not see shut-off valves under the sink, you will need to turn off the main water supply to your home.

Disconnect the Water Supply Lines
With the water off, place a bucket or a towel beneath the sink to catch any residual water. Using the adjustable wrench, carefully loosen the nuts that secure the hot and cold supply lines to the bottom of the faucet handle. Once loose, unsight them by hand and allow any remaining water to drain into the bucket. Keep track of the supply lines; you will need to remove them completely to free the fixture from the mounting hardware.
| Connection Type | Description |
|---|---|
| Supply Line Nuts | Usually located directly under the handle, connecting the faucet to the valves. |
| Mounting Nut | The large nut securing the faucet to the deck of the sink, typically found directly below the handle. |
| Spray Hose Coupling | A locking mechanism connecting the pull-down sprayer to the faucet body. |
Release the Mounting Nut
After the supply lines are detached, you will see a large mounting nut or a metal thrust ring pressed against the underside of the sink. This component holds the entire faucet in place. Fit your basin wrench or an adjustable wrench into the slot of the nut and turn it counterclockwise. If it is stuck due to mineral buildup, gently tapping it with a wrench handle or using penetrating oil can help loosen it.
Detach the Hose and Handle
Once the mounting nut is free, carefully lift the faucet body slightly to release tension on the internal hoses. If your unit features a pull-down sprayer, locate the hose coupling at the base of the handle. Squeeze the tabs on the locking collar and pull the hose free from the faucet body. Finally, remove the handle by locating the set screw—usually on the underside of the handle—and loosening it with a screwdriver or hex key.

Remove the Old Faucet
With all connections severed, you can now lift the entire faucet assembly straight up and out of the sink. Be mindful of the flexible supply lines to avoid bending them sharply. At this stage, you can inspect the condition of the sink's mounting deck and the condition of the supply lines, deciding whether to reuse them or replace them during installation.
Clean Up and Prepare for Installation
Use a flashlight to look down into the hole and ensure no gaskets or washers are stuck to the underside of the sink. Wipe down the area to remove any grime or debris left behind by the old fixture. You are now ready to install your new faucet; having a clear, clean workspace ensures a smoother installation process and prevents parts from falling into the sink drain.























