Replacing a Mira shower flow valve is a task that transforms a frustrating daily inconvenience into a smooth, high-pressure experience. Whether your flow has diminished to a trickle or you are dealing with unpredictable temperature swings, the flow valve is often the culprit. This guide provides a detailed, step-by-step process to remove the old component and install a new one with confidence.
Before you begin, it is essential to understand that success hinges on preparation and the right tools. Mira showers utilize specific valve designs, so verifying your model number is crucial to ensure compatibility. Gathering your supplies beforehand prevents mid-job trips to the hardware store and keeps the process efficient and focused.
Preparation and Safety
Shutting Off the Water Supply
The most critical first step is to eliminate the water supply to your shower. Locate the dedicated isolation valves for the hot and cold lines, usually found under the sink or in a nearby access panel. Turn both handles clockwise to shut off the water, then open the shower faucet to drain any remaining pressure and water from the lines.

Tools and Replacement Parts
Assemble your toolkit to work efficiently. You will typically need an adjustable wrench, a set of screwdrivers (Phillips and flathead), a plumber’s tape, and a container to catch residual water. Of course, you will also need the new Mira flow valve, which is designed to match the exact specifications of your model to ensure a secure fit and optimal performance.
| Tool | Purpose |
| Adjustable Wrench | Loosening and tightening supply line nuts |
| Screwdriver Set | Removing the handle and trim plate |
| Plumber’s Tape | Ensuring a leak-proof seal on connections |
Removing the Old Valve
Accessing the Valve Cartridge
With the water off and drained, remove the shower handle by unscrewing the setscrew located at the back. Depending on your trim plate, you may need to unscrew a small cover to reveal this screw. Once the handle is off, carefully pull away the trim plate to expose the valve cartridge collar.
Extracting the Cartridge
Use a wrench to loosen and remove the retaining nut that holds the cartridge in place. Grip the cartridge body gently but firmly and pull it straight out of the valve body. Inspect the old unit for any debris or mineral buildup, as these can provide clues about the condition of your water supply and internal seals.

Installing the New Flow Valve
Preparing the Components
Unpack the new Mira flow valve and confirm that all internal components are present and undamaged. Apply a thin, even layer of plumber’s grease to the rubber seals on the cartridge. This lubrication ensures a tight seal, prevents friction during operation, and makes future maintenance easier.
Securing the Assembly
Insert the new cartridge into the valve body, aligning it precisely with the inlet ports. Hand-tighten the retaining nut securely, then use your wrench to give it an additional quarter-turn. Avoid overtightening, as this can crack the valve body or deform the seals, leading to leaks.
Final Steps and Testing
Reassembling the Trim
Carefully reattach the trim plate, ensuring it sits flush against the wall. Replace the setscrew and tighten it until the handle feels solid with no lateral movement. Reattach the shower handle, making sure the alignment arrow or marking points to "Hot" or "On" to guarantee intuitive operation.

Checking for Leaks and Pressure
Slowly turn the isolation valves counterclockwise to restore the water supply. Turn the shower on gradually and observe the connections for any signs of dripping. Once the flow is steady, test the temperature control to ensure the mixing valve is functioning correctly, delivering consistent performance without sudden bursts of hot or cold water.






















