Installing a hinge on a cabinet door might seem daunting, but with the right tools and a clear understanding of the process, you too can achieve this DIY project. We've simplified the details, ensuring the end result is a perfectly aligned, functional cabinet door.

Before you start, gather your tools: a drill, screwdriver, measuring tape, pencil, and the new hinges. Disassembly of the old hinge might require a hammer, pliers or channel locks. Ensure the hinges you have are the right size, usually 3-1/2" or 127mm for standard cabinet doors.

Preparation: Measure and Remove Old Hinges
First, measure the mortise (groove) on your existing hinge. This will help you determine where to drill on your new hinge placement. Write this measurement down.

Now, it's time to remove the old hinge: Use a screwdriver to unfasten the screws, then use pliers, channel locks, or even tap it with a hammer to loosen and remove the hinge from the door.
Locate the Mortise

Find the mortise on the cabinet face-frame. This is where your new hinge will be installed.
If you can't locate it, you might need to remove the door and hinge to identify it. Once located, remove any remaining screws and old hinge pieces for a clean workplace.
Drill New Hinge Location

Using your measurements, mark the center of the mortise on your new hinge. Position the hinge onto the cabinet face-frame, aligning the mark with the outer edge.
Using a drill bit the same size as your hinge's screw holes, drill through the marked points to create pilot holes. This ensures your screws go into solid wood, preventing the board from splitting.
Install New Hinge and Door

Without the hinge, place your cabinet door onto the face-frame. Mark the screw holes onto the door. Remove the door.
Position the hinge tightly against the cabinet face-frame, screwing it onto the pre-drilled holes. Ensure it aligns perfectly with the marks on your door.





Attach Hinge to Door
Position the door onto the face-frame, aligning the marked screw holes with the hinge. Using a screwdriver, lightly fasten the door to the hinge. Check the door swings smoothly.
The final step is to fully tighten all screws. Use a screwdriver and ensure you don't tighten too much as this can cause the hinge and door to warp. If adjusting the door's alignment, loosen and retighten screws as needed.
The final touch - stand back and admire your newly installed or reinstalled cabinet door! As you move forward with other DIY projects, remember, patience and precision are key. Happy building!