Stihl Chainsaw Sharpener Kit
STIHLS OFFICIAL 2 STROKE CARBURETOR TUNING PROCEDURE. Vintage Engine Repairs Watch on B My MS290 had develop a condition where at times it is impossible to pull the recoil; as if the saw is locked up.
This is when I try to pull fast to start the saw; you can pull the recoil slowly through each compression stage. Taking the plug out the saw pulls normally. I have been given a...
I saw a couple of you tube videos (from different people) who had bad comments about the Stihl HP Ultra 2 cycle oil. One of them concerned an insufficient amount of oil film in the crankcase. (That person fixes chainsaws).
I have had a Stihl chainsaw go bad on me that had minimal hours on it... Hi all - I've got a Stihl 025 that has become quite hard to pull-start. When I remove the spark plug, it's super easy.
I've tried pulling it with the plug out to see if it was hydrolocked; I'm fairly sure it's not. I've noticed that it's considerably easier to pull with the switch in the "off"... As in your case, the saw died almost immediately.
I think it did this twice. I put it back on full choke, pulled once, then back to half choke, pulled and it started & ran fine. Finicky, thy name is MS250.
Quadra-Fire 2700i Stihl MS250, Husky 562XP, Husky 395XP Homelite 5 ton electric splitter, Ariens 22 ton log splitter Fiskars X27 Why is it so hard to locate OEM Stihl parts online? Anyone else have this problem or do you guys use your local dealer? I bought my first new saw and it worked great for the first year, but a year later the bar no longer gets oil.
The oil pump is pumping oil just fine. If I take the bar off and run the saw I can see oil comming out, but if I put the bar on the oiler just deposits oil to the interior of the saw... Howdy fellas, I found a Stihl FS 55R string trimmer on someones curb for free and trying to see if I can get it going.
When I try to pull the rope to start it. Its very hard. I removed the spark plug and it turns over very easily.
Put the spark plug back in and hard to pull. Fuel tank was... I purchased a Stihl farm boss from ace hardware.
I used it for about 5 hours. Tried to use it again this year and it stalled at high rpm. I brought it to ace for repair and the mechanic says it needs a new carburator for $130.
Should have just bought a poulan for use them throw it away or rent... Hi everyone, I'm working on an old 056 super and the ignition failed. Well as you may know, there are 2 different types of ignition systems used on these.
Bosch and sem. Mine is sem. The Bosch one is the one froggysail posted about fixing on arboristsite.
I bought an unreturnable part from my...
