Fused Spur In Bathroom Zone 3

A switched fused spur and flex-outlet must be installed outside of zone 1 and zone 2 and in a suitable location taking into account of external influences and the local environment, if possible ideally installed outside of the bathroom altogether. Flex. Your electrician is right, a switched fused spur inside the bathroom is totally unsafe and not compliant with BS7671:2008 wiring regulations.

The work should have been notified to building control under part P of the building regulations, so due to the cowboy that you hired to fit the radiator, they have now exposed you to a potential fine from building control for breaking the law and you. Switched fused spurs are commonly used in bathrooms for electrical installations. They serve as a convenient and efficient way to control power supply to various bathroom appliances, such as heated towel rails, electric showers, and extraction fans.

The main advantage of using a switched fused spur in a bathroom is that it provides a safe and easily accessible means of isolating power to. Conclusion Fused spurs are a safe and compliant solution for powering bathroom appliances, but their installation must follow BS 7671 Wiring Regulations and Part P of the Building Regulations. While placement in Zones 0 and 1 is strictly prohibited, they can be installed in Zone 2 with an IPX4 rating or in outside zones for optimal safety.

The 17th Edition, published in 2008, introduced a number of amendments. These included changes to the zonal system, RCD protection on all bathroom circuits, and 230 V socket outlets permitted 3 m horizontally from the boundary of zone 1; supplementary equipotential bonding may be omitted subject to the Wiring Regulations being met. In the bathroom it had an electric (oil filled I assume) heated towel rail/radiator.

This was powered via a switched, fused spur with a flex outlet that was positioned approximately 6" off the floor and about 3" away from the bath panel at the opposite end to the taps. (i) In zone 0: IPX7 (ii) In zones 1 and 2: IPX4." But that is a bathroom not a wet room, so even when in zones 1 and 2 one has to class it as some where that may have water jets hit it, one does try to keep water to within the bath or shower tray with a bathroom, but with a wet room the whole floor is the shower tray. Heated Towel Rails Must be fixed and connected via a fused spur with RCD protection.

Example: A towel rail with a programmable thermostat in Zone 2. Lighting Must meet zone-specific IP ratings. Example: IP65.

A fused spur in itself won't help, but an RCD fused spur would offer the RCD protection, this could go wall mounted up high in the bathroom (provided it's outside of the zones) or in the loft. Electrical Fitting an electric towel radiator with fused spur Anonymous user 14 March 2024 - 2.36 PM Hello, A DIY'er here. I'm hoping someone would be kind enough to share 2 mins of their time on the above subject? Basically, I'm about to fit an electric towel radiator in our bathroom.

I've checked the specs of zones and understand the requirements for zones; 0,1 & 2. Upon double.