Few household issues are as frustrating than the persistent drip of a leaky tub faucet, especially when it occurs in the middle of the night. If you have a Delta double-handle model, you are dealing with a proven design that relies on a ceramic cartridge to control water flow and temperature. While these systems are durable, the washers and seals inside can wear out over time, leading to annoying leaks from the spout or handles. This guide provides a detailed, step-by-step process to diagnose and fix the issue, saving you the cost of a plumber and restoring your bathroom to its quiet, efficient state.
Understanding Your Delta Faucet Mechanics
Before diving into the repair, it helps to understand how a dual-handle Delta faucet operates. Unlike single-handle models that mix hot and cold within one valve, double-handle units control hot and cold water separately. Each handle connects to a stem assembly that features a cartridge or a washer-driven mechanism. When you turn a handle, it raises or lowers a rubber washer against a valve seat to stop the flow. If these components crack, compress incorrectly, or scale builds up, water bypasses the seal and results in a consistent drip, even when the handle is in the "off" position.
Gathering the Right Tools and Parts
Preparation is the key to a smooth repair, and rushing to fix the leak without the correct items often leads to half-steps and damaged components. You will need an adjustable wrench, a set of Phillips and flat-head screwdrivers, and a cartridge puller specific to Delta models. It is highly recommended to visit a hardware store and bring the old cartridge or the model number of your faucet to ensure an exact match. Additionally, having plumber’s tape, a small bucket, and some rags will streamline the process and keep your workspace dry.

Shutting Down the Water Supply Safely
Never attempt to disassemble a pressurized faucet, as doing so can release sudden bursts of water and cause significant damage. Locate the shut-off valves under the sink; if your plumbing is older and lacks these, you will need to turn off the main water supply to the house. Open the tub faucet to drain the remaining water from the lines before proceeding. Verify that the water is fully off by turning the handles; if the spout remains dry, you have successfully isolated the fixture and can move on to disassembly without risk.
Removing the Handle and Inspecting the Cartridge
With the water off, use a screwdriver to remove the small cap on the top of the handle, revealing the mounting screw. Once the handle is off, you will see the stem and cartridge that control the water flow. Use a cartridge puller to carefully extract the old component, taking care not to scratch the surrounding metal. Examine the cartridge for cracks, mineral deposits, or worn seals. If the issue is a faulty O-ring or damaged cartridge, this is the source of your leak, and replacing it will solve the problem.
Replacing the Cartridge and Reassembling
Before installing the new cartridge, wrap the new O-ring with a light coat of plumber’s grease to ensure a smooth, watertight fit. Insert the replacement cartridge into the faucet body, aligning it precisely with the inlet ports. Use the cartridge puller or a gentle tapping motion to seat it firmly in place. Reattach the handle, tighten the mounting screw to the manufacturer’s specifications, and restore the water supply. Turn the handles slowly to check for proper alignment and to purge any air from the lines.

Testing for Leaks and Final Adjustments
After the fixture is reassembled, turn the water back on fully and let the faucet run for a minute or two. Observe the base of the handles and the spout for any residual drips; this confirms that the new cartridge is creating a complete seal. If the leak persists, double-check that the cartridge is seated correctly or inspect the valve seats for debris that might prevent a proper seal. Once the dripping stops, you have successfully completed the repair and can enjoy your quiet, efficient bathroom once more.






















