The previous extractor fan used wire nuts in a metal-enclosed space similar to a junction box, but for this new model the wires just dangle out of the extractor fan module, and there's nothing in the instructions about a junction box. Leaving the wires dangling next to the insulation in the ceiling kinda freaks me out. Just trust me on this one most bathroom fart fans junction box are freaking small and there is not much room to work around at all.
I wish the fan manufacters pay attetion what we electrician been complain about very small junction box area and it really akward design to boot. As with light fixtures and receptacles, staple the cable within 1 ft. of the fan box 1.
Insert a cable connector into a junction box knockout, feed the cable through it, and strip the cable sheathing 2. Does behind the fan count? There's enough depth that I could mount a box off to the top left of the picture, do the splice inside the box, and have the new wire go to the bottom left for the new fan. The associated lights are about 12-14" up from the top of the fan cutout, presumably with a box there.
Should I just run a new unspliced line from. Next, connect the white wire from the fan to the white wire in the junction box, using another wire connector. Repeat this step for the black wires, connecting the black wire from the fan to the black wire in the junction box.
Finally, if your fan has a separate light or heater, connect the corresponding wires as instructed by the manufacturer. Before installing a bathroom fan, it is crucial to prepare the junction box properly. The junction box serves as the connection point for electrical wires and helps protect the wiring connections from damage.
I think you have too many wires, especially earth wires, for a single box so my solution would be to use two boxes side by side. Bring power into one of them, across to the other and then out from there. Use one of the boxes for the lights and the other for the fan and shaver socket.
You can link the spare terminals in the boxes for switched live. Electrical - AC & DC - Junction Box and Bath fan and light fixture - I have junction box next to a Bathroom fan/lights. Can I move the junction box wires in the Bathroom fan/lights box?
How to Replace a Bathroom Exhaust Fan and Ductwork photo tutorial. Connect the wiring and flexible air duct then mount the fan in the drywall ceiling. Which is best depends on the nuances of the situation.
Extend the conduit and pull new longer wires from the closest upstream junction box. Add a junction box at the end of the conduit and extend with additional conduit and new wires from that box. Note that any junction box must remain accessible, but this can include attic space with an.
