How to Put a Knob on a Cabinet: A Step-by-Step Guide
Are you tired of staring at a cabinet door or drawer that's missing a knob? Or perhaps you're ready to upgrade your cabinet hardware for a fresh new look? Either way, you're in the right place. In this comprehensive guide, we'll walk you through the process of putting a knob on a cabinet, from start to finish. No need to call a professional; with the right tools and a bit of patience, you can do this yourself.
Tools You'll Need
Before you begin, make sure you have the following tools and materials on hand:
- New cabinet knobs
- Screwdriver (Philips or flathead, depending on your hardware)
- Drill (if your new knobs require larger holes)
- Drill bit (if needed, match the size of your new knob's screw)
- Tape measure
- Pencil
- Sandpaper (optional, for smoothing rough edges)
Measure and Mark
First things first, you need to measure and mark where you want your new knob to go. Most cabinets have pre-drilled holes, so you can use these as a guide. However, if your cabinet is new or doesn't have existing holes, you'll need to measure and mark your own.

For a standard cabinet door or drawer, the center of the knob should be about 2-3 inches from the top and 1-2 inches from the side. However, these measurements can vary depending on the size and style of your cabinet and knob. Use a tape measure to find the center point, then mark it with a pencil.
Remove the Old Hardware
Before you can install your new knob, you'll need to remove the old hardware. If your cabinet already has knobs or pulls, use a screwdriver to remove them. If there are no existing holes, you can skip this step.
If you're replacing old knobs with new ones that have a similar design, you might not need to drill new holes. However, if your new knobs are a different size or style, you'll need to drill new holes to accommodate them.

Drill New Holes (if needed)
If your new knob requires larger holes, you'll need to drill them yourself. Choose a drill bit that matches the size of your new knob's screw. Place the tip of the drill bit at your marked point, then drill straight down, applying steady pressure.
Be careful not to drill too deeply; you only need to go through the front face of the cabinet door or drawer. If you drill too far, you could damage the inside of the cabinet. Once you've drilled the hole, use sandpaper to smooth any rough edges.
Attach the New Knob
Now that you've prepared your cabinet, it's time to attach the new knob. If your new knob came with screws, use these. If not, you can use the screws that came with your old hardware, as long as they're the right size.
Place the knob on the marked spot, then use the screwdriver to attach it. Tighten the screw gently, being careful not to overtighten and strip the threads. Once the knob is securely attached, give it a gentle tug to make sure it's on tight.
Test Your New Knob
Finally, give your new knob a test run. Open and close the cabinet door or drawer a few times to make sure the knob is secure and functioning properly. If everything looks and feels good, step back and admire your handiwork!
And there you have it - a comprehensive guide on how to put a knob on a cabinet. With a little bit of time and effort, you can upgrade your cabinet hardware and give your space a fresh new look. Happy DIY-ing!