Towing a side-by-side UTV (Utility Task Vehicle) safely requires more than just hooking a trailer to your truck. Whether you're heading to the trails for a weekend of rock crawling or transporting your rig between job sites, improper towing can lead to damaged equipment, dangerous highway situations, and costly fines. Understanding the right equipment, techniques, and safety protocols is essential for every UTV owner.
What Is a Side-by-Side Vehicle?
A side-by-side vehicle, commonly known as a UTV or SxS, is an off-road vehicle designed with a bench or bucket seats positioned next to each other. Unlike ATVs, they typically feature a roll cage, steering wheel, and a cargo bed. Side-by-sides are built for everything from recreation to farm work, but their width and weight make towing them a unique challenge compared to smaller off-road machines.
Choosing the Right Trailer for Towing a Side-by-Side
The foundation of safe UTV transport starts with proper trailer selection. Not every flatbed or utility trailer is designed to accommodate the width and gross weight of a side-by-side. Loading on an undersized trailer compromises stability and puts undue stress on your tow vehicle.
Trailer Size and Weight Capacity
Most full-size side-by-sides measure around 60 to 64 inches wide. Your trailer bed must be wider than that, ideally 77 inches or more, with adequate clearance on both sides for loading and securing tie-downs. Look for trailers rated for at least 2,000 pounds GVWR (Gross Vehicle Weight Rating), though heavier rigs with rollover protection, aftermarket cages, or accessories may weigh over 1,800 pounds empty. Always account for added gear.
Trailer Types: Utility vs. Enclosed vs. Tilt
Open flatbed trailers are the most popular choice because they offer easy loading via built-in ramps and unrestricted airflow around the machine. Enclosed trailers provide weather and theft protection but add significant weight and usually cost more. Tilt-bed trailers eliminate ramps entirely—the entire deck tilts to ground level, making loading solo-friendly and reducing the risk of inadequate ramp angle damaging your front bumper.
Critical Equipment for Safe UTV Towing
Beyond the trailer itself, several pieces of equipment are non-negotiable for securing a side-by-side during transit. The DOT requires that cargo be properly immobilized, but beyond legal compliance, proper securing practices prevent damage to your machine and protect other drivers on the road.
- Tie-down straps or chains: Use ratchet straps rated for at least 1.5 times the weight of your UTV. Soft loop straps protect suspension components from scratches and gouging. Avoid using bungee cords, which are completely inadequate for this application.
- Wheel chocks or nets: These hold the tires stationary against the trailer deck and prevent any fore-aft shifting during acceleration and braking.
- D-ring anchors: Your trailer should have welded D-rings or equivalent anchor points bolted to the frame, not just the plywood decking. Inspect them for rust or deformation before every trip.
- Quality ramps: If using ramps, ensure they're rated for your UTV's total loaded weight and feature a high-traction surface. Store them securely in the cargo bed or on the trailer during transport.
How to Load and Secure Your Side-by-Side
Loading is arguably the most dangerous part of the entire process. Statistics from the National Trails Training Partnership suggest many UTV injuries happen during loading and unloading due to improper ramp angle, uneven ground surfaces, or operator error.
Step-by-Step Loading Process
Position your trailer on as flat and level a surface as possible. A sloped or uneven surface increases the chances of the vehicle rolling off the ramps. Attach the ramps to the trailer deck securely—never rest them loosely on the edge. Drive or winch the side-by-side up the ramps in low range at an idle throttle. Once on the deck, center the machine and set the parking brake. Shift into park (or in the case of manual UTVs, in gear) before beginning to secure it.
Securing Your UTV to the Trailer
Run straps through the front and rear frame points or wheel hubs, connecting each to a dedicated anchor on the trailer. Four tie-down points is the minimum standard—two in front, two in rear. Attach the straps at approximately 45-degree angles to maximize both downward and lateral force. After hand-tightening the ratchets, give each one a final pull with the ratchet handle. Once you've completed this, check that the suspension has compressed slightly. This prevents excessive bouncing during highway travel. Visually inspect every connection before departure.
Driving Considerations When Towing
A loaded UTV trailer significantly changes the handling dynamics of your tow vehicle. Acceleration is reduced, braking distance increases dramatically, and wind gusts from passing semis can push the trailer in unexpected ways. Keep speed moderate, especially on highways with posted speed limits above 60 mph. Sudden lane changes or hard braking should be anticipated well in advance.
Make frequent stops to check your tie-downs. The vibration of highway travel can cause ratchets to loosen over time. On trips exceeding two hours, pull over at a rest stop, retighten all straps, and confirm everything is still tight. It takes five minutes and could prevent a catastrophic road incident.
Common Mistakes When Towing a Side-by-Side
| Mistake | Why It's Dangerous |
|---|---|
| Using old or frayed straps | Breakage at highway speed can send your UTV off the trailer |
| Overloading the trailer | Exceeds axle ratings, causing tire blowouts or frame failure |
| Ignoring tongue weight specifications | Too little causes trailer sway; too much overloads the tow hitch and rear axle |
| Skipping the pre-departure inspection | Undetected loose chains or failing ramps are leading causes of accidents |
| Not checking tire pressure on the trailer | Underinflated trailer tires overheat and are prone to blowouts during long drives |
Legal and Insurance Considerations
Many state DMVs and DOT agencies have regulations governing trailer width, lighting requirements, and registration. Trailers over a certain GVWR—often around 3,000 pounds—may require their own registration, license plate, and annual inspection depending on your state. Before heading out on long-distance towing trips, verify that your insurance policy covers the UTV while on a trailer. Standard auto insurance may not extend to off-road vehicles in transit, and separate coverage or a rider could be necessary.
Towing a side-by-side is straightforward when you invest in the right equipment, follow a consistent loading routine, and never cut corners on safety. Treat every trip to the trails with the same diligence you'd apply to hauling any other heavy load—because that's exactly what it is. Your UTV, your tow vehicle, and everyone else on the road deserve that level of preparation.
