Removing shiplap to install drywall is a common project for homeowners looking to update a room with a more modern, minimalist, or smoother aesthetic. While shiplap offers charm and texture, drywall provides a clean canvas for paint, wallpaper, and a more uniform light reflection. This process requires careful planning, the right tools, and attention to detail to ensure the final result is both structurally sound and visually perfect.
Assessing the Scope and Preparing the Space
Before you remove a single board, evaluate the condition of the existing shiplap. If it is secured with nails or thin screws, extraction is generally straightforward. However, if the boards are glued or nailed into a stud backing, removal becomes more labor-intensive. You must also decide whether to salvage the shiplap for future projects or dispose of it, as this will affect your workflow. Clearing the room of furniture and covering the floor with a sturdy drop cloth will protect your belongings from dust and accidental damage during demolition.
Tools You Will Need
- pry bar or cat's paw hammer
- Reciprocating saw with a wood-cutting blade
- Utility knife
- Safety goggles and dust mask
- Shop vacuum
- Stud finder
Removing the Shiplap Boards
The removal process requires patience to avoid damaging the underlying wall structure. Start by removing any trim or molding around the edges of the shiplap. Use a pry bar to gently wiggle the boards loose, working from the top down to prevent the wood from splintering. For boards that are stubborn, a reciprocating saw fitted with a blade designed for cutting wood can be used to sever the nails or screws behind the board. Always wear safety gear to protect against flying debris and sharp edges.

Inspecting and Preparing the Wall Framework
Once the shiplap is removed, you will be looking at the wall frame, which is usually made of vertical wooden studs. At this stage, inspect the studs for any signs of rot, pest damage, or protruding nails. Use a stud finder to locate the exact position of the studs so you know where to secure your new drywall. If the old lath or backing is uneven or loose, you may need to reinforce it with new wood or shims to create a flat and stable surface for the drywall sheets.
Repairing Damaged Studs
- Replace any rotten or weak studs with new lumber cut to size.
- Secure loose backings with construction adhesive or additional nails.
- Fill holes or gaps with wood filler and sand smooth.
- Ensure the frame is level and plumb before proceeding.
Installing Drywall Over the Existing Structure
With a clean and stable framework ready, you can proceed to install the drywall. Measure the walls carefully and cut the drywall sheets to fit precisely between the studs. It is generally easier to cut the boards to match the studs rather than forcing standard 4x8 sheets into awkward spaces. Lift the drywall into position and secure it with drywall screws, placing screws every 6 to 8 inches along the studs and about 12 inches along the edges. Be sure to countersink the screws slightly below the surface to facilitate a smooth finish.
Finishing the Transition
After the drywall is up, the transition is nearly complete. Tape the seams with drywall tape and apply a layer of joint compound, or mud, spreading it smoothly with a taping knife. Allow the compound to dry, then sand the area until it is flush with the surrounding surface. At this point, the wall is ready for painting, texturing, or installing wallpaper. The result is a sleek, uniform surface that provides endless design possibilities, effectively erasing the rustic look of shiplap.
























