Is your Dometic awning failing to respond to controls or making unusual noises? You might need to replace the awning motor. While this task requires a bit of elbow grease, it's definitely doable with some basic tools and step-by-step guidance.

Before you begin, ensure you've gathered all the necessary materials and have a clear understanding of the process. This guide will walk you through the process, from prepping the awning to installing the new motor and ensuring everything works smoothly.

Preparation and Safety Measures
Before you get started, ensure you have the following tools and materials on hand:

- New Dometic awning motor (ensure it matches your existing model)
- Screwdriver (Phillips and flathead)
- Pliers
- Wire strippers
- Electrical tape
- Drawer slides (if replacing the entire assembly)
Safety first! Disconnect the power source to your awning before starting. Also, ensure you're working in a stable, well-lit environment. If you're uncomfortable with any part of the process, don't hesitate to consult a professional.

Disconnecting the Old Motor
Begin by removing the cover of the awning motor. This is usually held in place with screws or clips. Once removed, you'll see the motor and gear assembly.
Using your screwdriver, loosen and remove the motor mounting screws. Carefully slide the motor out, disconnecting any wiring or control cable attachments. If the motor is attached to the awning arm directly, you'll need to carefully remove the arm as well.

Inspecting the Awning Assembly
Before installing the new motor, inspect the awning assembly for any signs of wear or damage. Check the arm, gears, and any mounting brackets for rust, bend, or breakage. If necessary, replace these components before installing the new motor.
If you're replacing the entire awning assembly, use the old drawer slides as a template to mark and cut new slides to the correct length. Ensure they're securely attached to the awning frame before proceeding.

Installing the New Dometic Awning Motor
Begin by preparing the new motor. Ensure it's clean and free of any debris. If your new motor doesn't come with preinstalled leads, strip about 3/4 inch of insulation from the ends of the wires.




















Mounting the Motor
Align the new motor with the mounting holes in the awning assembly. Insert the mounting screws loosely and ensure they're properly aligned. Once satisfied with the positioning, tighten the screws securely.
Reattach the control cable and any wiring to the motor. Ensure all connections are secure and fully inserted. Use electrical tape to secure any loose wires and prevent them from being pulled or damaged.
Reassembly and Testing
Reassemble the awning, ensuring the arms slide smoothly into place. Replace the motor cover and reattach any screws or clips you removed earlier.
Reconnect the power source and give your new motor a test run. Activate the awning control, and watch as your new motor smoothly extends and retracts the awning. If it functions as expected, you've successfully replaced your Dometic awning motor!
Regularly inspect your awning for any signs of wear or damage. With proper maintenance and care, you'll enjoy many more years of hassle-free use from your Dometic awning.