Whether it's to update the look of your Dometic power awning or replace a worn-out fabric, learning how to replace the fabric on a Dometic power awning can save you time and money. This guide will walk you through the process, making it an accessible DIY project. Let's dive into the step-by-step process.

Before you start, ensure you have all the necessary tools and materials. You'll need a new fabric panel, scissors, a measuring tape, a sewing machine (or needle and thread if you prefer manual sewing), and a flat surface to work on. It's also a good idea to lay out the new fabric alongside the old one for comparison.

Preparation and Removal
The first step involves preparing your awning for thefabric replacement and removing the old fabric.

Start by measuring the current fabric panel to ensure you get the right size for the replacement. Most Dometic power awnings use standard fabric panel sizes, but it's always a good idea to double-check.
Measuring the Old Fabric

Extending the awning fully, carefully measure the length and width of the fabric from one seam to the next. Note down the measurements, and compare them with the dimensions of your new fabric to ensure they match.
If your awning has valance or trim, make sure to account for those measurements as well. If your new fabric doesn't include these, you might need to add them yourself.
Removing the Old Fabric

With the measurements taken, carefully remove the old fabric. Start by unzipping the valance or trim if present, then unclip the fabric from the awning arms or brackets. Be gentle to avoid damaging the canvas.
Once unclipped, the fabric should roll up easily. The old fabric might be attached with screws, so have a screwdriver handy if needed. If the old fabric is stuck due to age or adhesive, you might need to cut it off, but try to avoid this if possible.
Installing the New Fabric

With the old fabric removed, it's time to install the new one.
First, lay out the new fabric on a flat surface. Make sure the pattern or design is facing the right way up. Align the awning arm or bracket clips with the corresponding holes in the new fabric. If the new fabric has a valance or trim, this should be attached at this stage as well.




















Attaching the New Fabric
The process of attaching the new fabric involves reversing the steps you took to remove the old one. Clip the fabric onto the awning arms or brackets, lining up the holes with the corresponding clips.
If there were any screws or fasteners securing the old fabric, use new ones to attach the new fabric. Always ensure your awning is properly secured and tensioned for safe operation.
Sewing the Valance or Trim (if necessary)
If your new fabric doesn't have a valance or trim, or you need to adjust its size, you can sew one on yourself. Measure the width of the awning and cut the valance or trim fabric to size. Then, sew it onto the bottom edge of the awning fabric, ensuring it's straight and evenly distributed.
If your awning has side trims, measure and cut these to size as well, then sew them onto the sides of the awning fabric.
Congratulations! You've successfully replaced the fabric on your Dometic power awning. Regularly inspect your awning for any signs of wear or damage to ensure its longevity. Happy camping!