Zone 2 Bathroom Rating

What are bathroom zones and IP ratings? How do you know what IP rating YOU need? We explain how to fit bathroom electrics safely and with legal compliance. The bathroom zones are as follows: Zone 0: The area inside the bath or shower - this would also apply to shower enclosures and wet rooms too. Zone 1: The area above the bath or shower up to a height of 2.25 from floor level.

Zone 2: The area reaching 0.6m outside the bath's perimeter, up to a height of 2.25m from the floor. Zone 2 Bathroom Lights can be used in an area stretching 0.6m outside the perimeter of the bath and to a height of 2.25 from the floor. In this zone IP rating of at least IP44 is required.

Learn how to safely install electrics into bathroom zones, showers, or wet rooms using your bs7627 18th edition guide. IP Ratings and Bathroom Zones explained February 22, 2017 Katie A bathroom can be a confusing place in your home to heat, with many radiators being unsuitable for installation. The bathroom is a space where functionality and ambience are equally important.

Achieving the right balance requires careful consideration of your bathroom lighting plan, especially given the presence of water and electricity. This guide will delve into the intricacies of bathroom lighting, covering everything from understanding IP ratings and bathroom zones to selecting the perfect fixtures. Enjoy our bathroom zoning guide explains the classification of zones and where to install extractor fans and IEE Wiring Regulations.

Bathroom Zone 2 is the area that sits on either side of Zone 1, sitting at a distance of 0.6 metres away from the bath and/or shower and at a height of 2.25 metres if directly above. These areas require IP ratings of IPX4. Though again, if pressurised water jets are to be used to clean this area then a rating of IPX5 is preferable.

For zone 0, light fittings need to be at least a minimum of IP67 which means immersion proof. Lights used in zone 0 will also need to be low voltage, with a maximum of 12V. Zone 1 This is the area of the bathroom that is directly above the bath tub and the shower, up to a height of 2.25m from the bathroom floor and at a 1.2m radius from water.

Zone 2 is an area stretching 0.6m outside the perimeter of the bath and to a height of 2.25m from the floor. In this zone an IP rating of at least IP44 is required. In addition it is good practice to consider the area around a wash basin, within a 60cm radius of any tap to be considered as zone 2.