Zone 3 Bathroom Nz

Bathroom Zones The Australia and New Zealand Standard AS/NZS 3000:2018 identifies the zones in a bathroom and the IP rating required for electrical items installed in each zone. Bathroom Wet Zones are 3 special areas in your bathroom where any eletrical fitting needs to be more water resistant, we can help you figure out each zone with handy diagrams and show you the specicifications you need for your bathroom and vanity lighting. The Australia and New Zealand Standard AS/NZS 3000:2018 identifies the zones in a bathroom and the IP rating required for electrical items installed in each zone.

There are specific rules when it comes to switches and power points in wet areas. These rules are set out by the AS/NZ 3000 Electrical Wiring Rules. Legislation Information 6.2.4.3 Switches and other accessories Switches and other accessories shall not be installed within 0.3m of the floor of a bathroom, laundry or other similar location where the floor is likely to become wet.

The following. The NZ Electrical Code of Practice published by Work Safe NZ (NZ Govt) has regulations covering the light fittings that can be installed in bathrooms. Follow this link for a simple breakdown of the requirements.

All of these lights are suitable for Zone 3. To keep things simple, NZ regulations divide the various areas in a bathroom into zones. Zone 0: Inside the bath or shower area - No electrical equipment should be installed in this area unless specially designed to be submerged, such as waterproof lighting.

BATHROOM ZONING Bathroom Zoning is linked to Ingress Protection (IP). The purpose is to ensure fittings have the correct protection against water. This is split into zones Zone 0: Inside the bath or shower.

These must be SELV (Low voltage i.e. 12V Max). Minimum IP rating IPx7 (IP67) Zone 1: Above the bath or shower to a height of 2.85m.

What splash-protection do I need in a bathroom? Electrical Safety in bathrooms divides into four zones. In Zone '0' which defines being within in the sink bowl, bath tub or shower bowl any electrical appliance must be IP67 (full immersion capable) and low voltage. It is imperative to follow the specifications rigorously during installation to guarantee that the system meets the New Zealand Building Code (NZBC) regulations.

Whether it involves modifying the original design or creating a new plan, please ensure that the alternative solution is submitted to the council for review. In addition to the above, if there is a likelihood of water jets being used for cleaning purpose in zones 1 and 2, a fitting rated a minimum IP65 must be used. Now that this has been explained, always make sure to purchase bathroom lighting according to these standards to make sure that your bathroom is always safe.