2013 Ford Explorer Wheel Bearing Replacement: A Comprehensive Guide
If your 2013 Ford Explorer is exhibiting symptoms like unusual noises from the wheels, vibrations, or wandering, it might be time to inspect the wheel bearings. This guide will walk you through the process of replacing them, ensuring your vehicle's safety and smooth operation.
Understanding Wheel Bearings
Wheel bearings are critical components that allow your vehicle's wheels to spin smoothly and safely. They are located within the hub assembly and consist of a set of steel balls or rollers, a race (inner and outer), and a cage to keep the balls or rollers in place.
Over time, these components wear out due to constant use and exposure to elements like dirt, moisture, and road debris. When this happens, it's essential to replace them to prevent further damage and ensure your vehicle's performance and safety.

Symptoms of Failing Wheel Bearings
- Noise: A failing wheel bearing may produce a high-pitched grinding, growling, or whining sound. This noise can change with the vehicle's speed.
- Vibration: You might feel a vibration in the steering wheel, the entire vehicle, or just the affected wheel when driving at higher speeds.
- Wandering: The vehicle may pull to one side or the other, making it difficult to maintain a straight path.
- Worn Tires: Uneven or excessive tire wear can indicate a problem with the wheel bearings.
Tools and Parts Needed for Replacement
Before you begin, gather the following tools and parts:
| Tools | Parts |
|---|---|
| Jack and jack stands | New wheel bearings (inner and outer) |
| Lug wrench | New wheel speed sensor (if applicable) |
| Socket set | New hub assembly (if applicable) |
| Breaker bar | Locking pliers |
| C-clamp | Wheel bearing grease |
| Hammer | Torque wrench |
| Pry bar | Antiseize compound |
Step-by-Step Wheel Bearing Replacement
Preparation
Before starting, ensure your vehicle is on a level surface and safely supported by jack stands. Block the opposite wheel to prevent the vehicle from rolling. Remove the lug nuts and lower the tire until it's just off the ground.
Removing the Old Wheel Bearings
Using a breaker bar and socket, loosen and remove the lug nuts. Remove the tire and wheel assembly. Using a pry bar, gently tap the hub assembly to break the rust and make it easier to remove. Remove the cotter pin and castle nut, then use a hammer and a punch to drive out the C-clip.

Use a C-clamp to press the inner bearing out of the hub. If it's stuck, you may need to use a hammer and a punch to gently tap it out. Remove the outer bearing, which may require using a press or a large socket and a hammer.
Inspecting the Hub and Race
Inspect the hub and race for any signs of damage or wear. If they are in good condition, clean them thoroughly to remove any dirt or debris. If they are damaged, you will need to replace the entire hub assembly.
Installing the New Wheel Bearings
Apply a small amount of antiseize compound to the outer bearing to prevent it from seizing. Press the outer bearing into place using a press or a large socket and a hammer. Apply grease to the inner bearing and press it into the hub.
Reinstall the C-clip, castle nut, and cotter pin. Tighten the castle nut to the specified torque (usually around 80-100 ft-lbs for a 2013 Ford Explorer). Reinstall the tire and wheel assembly, and tighten the lug nuts to the specified torque (usually around 80-100 ft-lbs).
Final Checks
Lower the vehicle and remove the jack stands. Take the vehicle for a test drive to ensure the new wheel bearings are functioning correctly. Listen for any unusual noises and check for vibrations or wandering. If everything feels normal, your 2013 Ford Explorer's wheel bearing replacement is complete.
Regular maintenance is key to keeping your vehicle running smoothly and safely. If you're unsure about any part of this process, don't hesitate to consult a professional mechanic. Happy wrenching!