Understanding the Generac 7550 EXL Oil Pressure Switch
The Generac 7550 EXL is a robust, industrial-grade generator designed to power through the toughest conditions. A critical component of this generator is the oil pressure switch, which plays a pivotal role in ensuring its longevity and reliable operation. This article delves into the intricacies of the Generac 7550 EXL oil pressure switch, its importance, how it works, and common issues you might encounter.
Why the Oil Pressure Switch is Crucial
The oil pressure switch is a safety feature that monitors the oil pressure in the generator's engine. It's designed to shut down the engine automatically if the oil pressure drops below a certain level, preventing severe engine damage due to lack of lubrication. In the case of the Generac 7550 EXL, this switch is a lifesaver, especially during extended runtime or heavy load conditions.
Understanding the Generac 7550 EXL Oil Pressure Switch
The Generac 7550 EXL oil pressure switch is a compact, yet powerful device. It's typically located on the engine's side, near the oil filter. The switch consists of a pressure-sensitive plunger that activates when the oil pressure reaches a specific level. When the engine starts, the oil pump begins to circulate oil, and as the pressure builds, the plunger in the switch extends, completing an electrical circuit that allows the engine to run.

How to Test the Oil Pressure Switch
Testing the oil pressure switch is a straightforward process. Here's a simple step-by-step guide:
- First, ensure the generator is off and has cooled down to prevent any burns.
- Locate the oil pressure switch on the engine's side.
- Using a multimeter set to the lowest resistance setting (usually denoted as 'Ω' or 'ohms'), touch the probes to the switch's terminals. If the switch is functioning correctly, you should see a reading of infinite resistance (OL) or a very high resistance (typically above 1 MΩ).
- If the switch is faulty, you might see a low resistance reading, indicating that the switch is stuck in the closed position.
Common Issues and Solutions
Like any other component, the oil pressure switch can fail over time. Here are a few common issues and their solutions:
| Issue | Solution |
|---|---|
| Switch doesn't activate at the correct oil pressure | Replace the switch with a new one. Ensure you get the correct part number (usually 370009220 for the Generac 7550 EXL). |
| Switch sticks in the closed position | Clean the switch terminals and the area around them. If the problem persists, replace the switch. |
| Generator shuts down due to low oil pressure, but the switch is fine | Check the oil level and condition. If the oil is low or contaminated, change it immediately. Also, inspect the oil pump and its drive mechanism for any signs of wear or damage. |
Preventive Maintenance Tips
Regular maintenance can extend the life of your Generac 7550 EXL oil pressure switch. Here are some tips:

- Check the oil level and condition regularly. Dirty or low oil can cause the switch to fail prematurely.
- Keep the engine clean. Dirt and debris can interfere with the switch's operation.
- Inspect the switch and its wiring harness during routine maintenance. Look for any signs of damage or corrosion.
In conclusion, the Generac 7550 EXL oil pressure switch is a vital component that deserves your attention. Regular checks and timely maintenance can ensure your generator runs smoothly and safely for years to come.