When it comes to tiling a wall, ensuring a smooth and even surface is crucial for a professional-looking finish. However, walls are not always perfectly flat, and this is where shimming comes in. Shimming involves filling in small gaps or leveling out uneven surfaces to create a smooth base for your tiles. Here's a comprehensive guide on how to shim a wall for tile, optimized for both SEO and human readers.
Understanding Wall Shimming
Wall shimming is a preparatory step in tiling that involves filling gaps, leveling surfaces, and creating a smooth base for your tiles. It's a crucial step that can significantly impact the final outcome of your tiling project. Shimming can be done using various materials, with thinset mortar and backer board being the most common.
When Do You Need to Shim a Wall?
Shimming is necessary when you notice any of the following issues with your wall:

- Cracks or holes that are larger than the width of your tile.
- Uneven surfaces or walls that are not perfectly plumb or level.
- Gaps between the wall and the floor or ceiling.
Shimming helps to create a smooth, even surface that will ensure your tiles are laid evenly and professionally.
Materials Needed for Shimming a Wall
Before you start, gather the following materials:
- Thinset mortar or joint compound (for small gaps)
- Backer board (for large gaps or uneven surfaces)
- Tape measure
- Level
- Trowel (for applying thinset mortar)
- Utility knife
- Screwdriver or drill (for securing backer board)
Shimming with Thinset Mortar
Thinset mortar is a versatile material that can be used to fill small gaps and level out minor unevenness. Here's how to use it:

- Mix the thinset mortar according to the manufacturer's instructions.
- Using a trowel, apply the mortar to the wall, filling in any gaps or uneven areas.
- Use a level to ensure the mortar is applied evenly and that the surface is smooth.
- Allow the mortar to dry according to the manufacturer's instructions before tiling.
Shimming with Backer Board
Backer board is typically used for larger gaps or uneven surfaces. It's a more involved process but provides a solid, level base for your tiles. Here's how to do it:
- Measure and cut the backer board to fit the area you need to shim.
- Using a level, ensure the board is plumb and level, then secure it to the wall using screws or nails.
- Apply thinset mortar over the seams and screw holes to create a smooth, even surface.
- Allow the mortar to dry before tiling.
Common Mistakes to Avoid When Shimming a Wall
While shimming might seem straightforward, there are a few common mistakes to avoid:
- Not allowing the shimmed area to dry completely before tiling.
- Using too much or too little thinset mortar.
- Not securing backer board firmly enough to the wall.
- Shimming over existing problems without addressing them first (e.g., shimming over a cracked wall without fixing the crack first).
Shimming a wall for tile is a crucial step in any tiling project. By understanding when and how to shim, you can ensure a smooth, even surface that will result in a professional-looking tile job. Always remember to allow the shimmed area to dry completely before tiling to prevent any issues with adhesion or longevity. Happy tiling!