Is your beloved Nike shirt or hoodie losing its iconic logo due to peeling? You're not alone. This is a common issue with many Nike garments, but don't despair. Here's a step-by-step guide on how to fix a peeling Nike logo on clothes, ensuring your favorite piece stays looking fresh and new.

Before we dive in, it's essential to understand that this process requires patience and gentle care. The goal is to restore your logo without causing further damage. So, let's roll up our sleeves and get started.

Gathering Your Tools
Before you begin, make sure you have the right tools for the job. Here's what you'll need:

- Iron
- Ironing board
- Hair straightener (optional, for small logos)
- Scissors
- Cotton swabs
- Rubbing alcohol
- Soft-bristled brush
- Tweezers
- Small, sharp knife (for removing excess glue)
Preparation

First, ensure your garment is clean and dry. Any dirt or moisture can interfere with the repair process. Lay your garment flat on an ironing board or a clean, hard surface.
If the logo is still attached but peeling, gently lift the edges using tweezers. Be careful not to pull it off completely. If the logo has already peeled off, carefully collect the pieces and set them aside.
Removing Excess Glue

Before reattaching the logo, you need to remove any excess glue. This step is crucial for a successful repair.
Using a small, sharp knife, carefully scrape off any excess glue from the garment. Be gentle to avoid damaging the fabric. Once you've removed as much glue as possible, use a cotton swab dipped in rubbing alcohol to clean the area. This will help the logo adhere better.
Reattaching the Logo

Now that the area is clean, it's time to reattach the logo. If the logo is still in one piece, carefully align it and place it back onto the garment. If it's in multiple pieces, match them up as best as you can before placing them onto the garment.
Using a soft-bristled brush, gently press down on the logo to ensure it's securely attached. Be careful not to rub too hard, as this could damage the logo or the fabric.




















Securing the Logo
To ensure the logo stays in place, you can use one of two methods: ironing or using a hair straightener.
Ironing: Place a clean cloth or pressing cloth over the logo to protect it from the iron. Set your iron to a medium heat setting (no steam) and press down firmly but gently for about 10-15 seconds. Lift the iron and check if the logo is secure. Repeat if necessary.
Hair Straightener: If the logo is small, you can use a hair straightener to secure it. Plug in the straightener and let it heat up. Once it's hot, carefully place the straightener over the logo and press down gently for about 5-10 seconds. Lift the straightener and check if the logo is secure. Repeat if necessary.
Finishing Touches
After securing the logo, let the garment cool completely. Once it's cool, gently rub the logo with your fingers to ensure it's fully adhered. If there are any rough edges, use a pair of scissors to carefully trim them.
Finally, wash your garment in cold water on a gentle cycle to ensure the logo stays in place. Avoid using bleach or harsh detergents, as they can damage the logo.
And there you have it! Your Nike logo is as good as new. With a little patience and care, you can extend the life of your favorite garments. Happy fixing!