Effect of initial ph on equilibrium biosorption capacity of

The biosorption capacity of a biosorbent which is obtained from the mass balance on the sorbate in a system Comparison of our chromium (VI) ions adsorption results with those found in the literatures Table 2 with solution volume V, is often used to acquire the experimental adsorption isotherms.
Abstract In this work, the biosorption of trivalent and hexavalent chromium has been studied using olive stone, a low-cost natural sorbent, analysing the pH effect in the biosorption process. Removal of Cr (III) and Cr (VI) with olive stone is very sensitive to solution pH .
Effect of ph on the rate of the biosorption of chromium by
'The effect of pH on chromium adsorption was investigated by varying the pH from 1 to 8. As shown in Fig.1, the removal efficiency of chromium decreases with the increase of pH from 2 to 8 and the maximum of biosorption by biomasses was observed at pH 2, in which the maximum of removal was obtained with Gelidium comeum.
The effect of pH , initial concentration, and salinity on the biosorption process of chromium (VI) ions using microalgae Chlorella sp.

The effect of pH, initial concentration, and salinity on the ...
The chromium (VII) (Cr 6+) ions are carcinogenic substances, and thus the presence of these substances in water is hazardous for the environment and humans. Therefore, removing Cr 6+ ions in water is required before the water is utilized or discharged into the environment. One of the processes that can be used is the biosorption process which involves microalgae as biosorbents. In this study ...
In this study, a response surface methodology (RSM) approach using central composite design (CCD) was investigated to develop a mathematical model and to optimize the effects of pH , adsorbent amount and temperature related to the hexavalent chromium removal by biosorption on peanut shells (PSh).

Effect of initial pH on equilibrium biosorption capacity of chromium ...
The biosorption of chromium (VI) ions from aqueous solutions on dried vegetative cell and spore-crystal mixture of Bacillus thuringiensis var. thuringiensis was tested using the batch method as ...
The biosorption capacity of C. virgatum biomass for total chromium was found to be 26.5 mg/g at pH 1.5 and 10 g/L biomass dosage, 90 min equilibrium time and 20 °C. From the D-R isotherm model, the mean free energy was calculated as 9.7 kJ/mol, indicating that the biosorption of total chromium was taken place by chemisorption.

Rapid adsorptive removal of chromium from wastewater using walnut ...
The solution pH was varied from 1.0 to 8.0 for an initial concentration of Cr (VI) as 20 mg/L at a constant biosorbent dose (0.2 g/L) with agitation at 200 rpm for 120 min at 298 K. Figure 4 a ...



The electrostatic interactions between chromium species and the sorbent matrix are the main determinants of Cr (VI) sorption. The pH plays a central role in the process by affecting chromium speciation and the net charge on sorbent surface.