Randy Ideas

"Mastering Mounts: How to Safely Secure Your Surfboard to Your Roof Rack"

Securing your surfboard to your roof rack safely and efficiently is a crucial skill every surf enthusiast should master. A well-secured board will not only prevent potential damage but also ensure your safety on the road. In this guide, we'll walk you through the process step-by-step, making sure you're equipped with the right equipment and techniques for a seamless strapping experience.

How to Strap Surfboards to Your Car: 17 Pro Tips
How to Strap Surfboards to Your Car: 17 Pro Tips

Before we dive in, it's essential to understand that the type of roof rack you have will slightly influence the process. However, the basic principles remain the same. For this guide, we'll focus on two of the most common roof rack systems: factory-installed and aftermarket racks with crossbars.

How To Strap Surfboards To A Roof Rack
How To Strap Surfboards To A Roof Rack

Gather Your Equipment

Ensuring you have the right tools at hand is the first step in any task. For strapping your surfboard to your roof rack, you'll need the following:

How to Tie a Surfboard on Your Car Safely
How to Tie a Surfboard on Your Car Safely

  • Surfboard straps (specifically designed for surfboards, not standard cargo straps)
  • Locking rings or cinch buckles
  • ScotchLOCK or similar tying material (for extra security)
  • Soft padding or blanket to protect your board's rails

Surfboard Straps

DIY Roof Rack Pads for Kayaks and Surfboards
DIY Roof Rack Pads for Kayaks and Surfboards

Surfboard straps are designed to wrap around the thickness of your board, providing a secure fit. Avoid using standard cargo straps as they can dig into your board, potentially causing damage. Opt for straps made from nylon or polypropylene fabric, which offer a good balance between strength and flexibility.

Tip: Consider the size of your board when purchasing straps. Boards vary in length, thickness, and diameter, so ensuring your straps are compatible is crucial.

Locking Rings or Cinch Buckles

How to use tie downs to secure your board
How to use tie downs to secure your board

These are essential for tightening your straps and creating a secure fit. They provide the tension needed to keep your board firmly in place. Cinch buckles are typically easier to use, while locking rings offer extra security and are often more durable.

Tip: Always use a locking mechanism when transporting your board to prevent theft or accidental unstrapping.

Preparing Your Surfboard and Roof Rack

Before strapping your board, prep both your board and roof rack to ensure a smooth process and maximum safety.

First, lay your surfboard onto soft padding or a blanket on a flat surface, ensuring the rails (the edges of the board) are protected. Next, position your roof rack crossbars. For factory-installed racks, the bars will be permanently fixed. If you have an aftermarket rack, make sure the crossbars are securely attached and running parallel to the direction of the vehicle's movement.

Positioning Your Board

The most stable position for your surfboard on the roof rack is with the board's deck (the flat surface where you stand) facing down and the rails resting on the crossbars. This position ensures the center of gravity is low, making your vehicle easier to control.

Tip: If your board has a different rocker (curve) on the nose and tail, position the board so the higher rocker points towards the front of your vehicle to balance the load more evenly.

Measuring and Cutting Your Straps

Before strapping your board, you'll need to cut your straps to the appropriate length. To do this, place your board on the roof rack, then measure from the top of the board's deck to the top of the crossbars. Subtract around an inch or two for slack, then cut all four straps to this length. This ensures your straps will wrap around your board and crossbars securely.

Note: It's better to cut your straps a little too long rather than too short. You can always trim excess length later, but you can't add length back if your straps are too short.

Securing Your Surfboard to the Roof Rack

With your board and roof rack prepped, it's time to secure your surfboard. Here's a step-by-step process:

Step 1: Attach the Front Straps

Place your board onto the roof rack. Starting at the front of your vehicle, wrap a strap around the top of the board's deck, then over the top of the crossbar, and finally, under the crossbar. Feed the excess strap through the cinch buckle or locking ring mechanism.

Tighten the strap by pulling on the loose end until the board is held firmly in place. Repeat this process on the other side of the board, ensuring both front straps are tight and equal to prevent the board from shifting.

Step 2: Secure the Rear of Your Board

Repeat the same process at the rear of your vehicle. Ensure the straps are pulled tight and the board is held securely.

Tip: Double-check that your board is positioned correctly and is sitting evenly on the crossbars. Uneven pressure could cause your board to wobble or vibrate while you're driving, potentially leading to damage.

Step 3: Reinforce the Straps

To ensure your board stays securely in place, it's a good idea to reinforce your straps. You can do this by threading the excess strap through the cinch buckle or locking ring mechanism a second time. Additionally, you can use ScotchLOCK or similar tying material to secure the straps in place.

Final Checks and Safe Driving Tips

Before setting off on your journey, perform a final check to ensure your board is securely strapped:

  • Tighten any loose straps.
  • Make sure the board isn't wobbling or vibrating.
  • Check that the board is sitting evenly on the crossbars.
  • Inspect all the straps to ensure they're properly locked.

Safety Tips:

  • Never exceed 65 mph (105 km/h) while driving with a board on the roof to minimize aerodynamic drag and vibration.
  • Avoid driving through car washes or tunnels with a board on the roof.
  • Check your board's position and strap tightness every 50 miles (80 kilometers) or so.

Finally, as you embark on your surfing adventure, remember that a secure board on your roof rack not only protects your valuable gear but also ensures your safety on the roads. Happy surfing!

Read Next