Overview of Networking How To Convert A Pon Interface To A Wan Interface In My

Is there a way to convert my router's " PON " interface (for fiber cables, see following picture) to a WAN interface (not LAN)? My final goal is to "see" the device as it was connected to the ISP (and visible from the Internet).

Is there a way to convert my router's " PON " interface (for fiber cables, see following picture) to a WAN interface (not LAN)? My final goal is to "see" the device as it was connected to the ISP (and visible from the Internet).
How to convert a PON interface to a WAN interface in my home router ...

How to convert a PON interface to a WAN interface in my home router? Roel Van de Paar 209K subscribers 5
This is commonly achieved by adding a secondary IP alias to the firewall's WAN interface . This translation ensures traffic originates from this local address, which enables access and overrides default firewall rules that would otherwise block traffic to private or bogon networks on the WAN interface .

Fiber optic to wan converter
I have a unifi dream machine pro, which has a sfp port for WAN . To make it work I had to clone the mac address from my old fiber modem to the dream machine pro and set an incoming vlan, because that's how my ISP handles the identification handshake.
Title:- Fiber To Wan | How to convert STC Huawei Gpon Fiber Router Lan Port into Wan Port |fiber to wan portTopics Covered in this Video (Try to Ignore this)...

Adding additional WAN Interfaces (USGATP Series)
In this article, we will take a closer look at how to " convert " a "reserved" LAN interface or the OPT interface to a WAN interface . Please also note, that in the Last Step (if You choose the "reserved" Interface ) there is no option to change the interface to external.
SFP+ As WAN Port with RJ45 SPF+ Module SFP+ Electrical Port modules exist to convert a traditional RJ45 ethernet connection for use with the SFP+ Port of your router.

How to turn first
how could I turn first-LAN port into WAN This should turn one of the lan ports (LAN1 or LAN4 depending on the interface numbering) into wan2. Use LuCI to set up the wan2 protocol according to your needs.





In the config files eth0 and eth1 are sometimes referred to as WAN and LAN and not the WAN /LAN RJ45-ports or the interfaces with these names. The igmpproxy package also seems to be hard coded to vlan1 ( in Lucie it only shows up in the LAN (=vlan1) GUI- interface tab.