Bmw 2 Series Seat Belt Not Retracting
One of the more annoying issues that pop up in older model BMWs is the front seat belts failing to retract all the way. The reason why seat belts stop retracting is that the fabric becomes dried out and brittle with age. This causes the belt to seize up in the spring mechanism, leaving half the belt annoyingly caught in your door when you try and close it.
Bimmerforums is the preferred online BMW Forum and community for BMW owners. At Bimmerforums, you will find technical how. Is your seat belt jammed, stuck in place, and refuses to retract? Don't stress.
This quick car repair is easier than you think, and you'll avoid the nuisance and safety hazard of a seat belt that just dangles loose. Read on to learn how to diagnose and fix a seat belt that won't retract or pull out. I take a pinch clamp.
pull the belt all the way out and clamp the so it won't retract. I then clean both sides of the belt with soapy solution and a scrub brush. After it dries I spray the whole belt with silicone spray.
Rear seat belt won't retract (& possible quick fix!) All times are GMT -5. The time now is 04:08 PM. Is your seat belt stuck, locked, or not retracting properly? This quick tutorial shows you how to troubleshoot and unlock your seat belt in minutes, no speci.
The proper way to fix a broken seatbelt retractor is to replace the retractor and belt with a new set. Twisted seatbelt You may have to remove the plastic trim to check and make sure that the seatbelt is not twisted. When this happens, it adds resistance and makes it hard for the retractor to pull the seatbelt back.
Causes of a Seat Belt That Won't Retract 1) Broken Retractor Spring A seat belt retracts via a spiral spring similar to what you would find in your steering wheel's clock spring. If this spring breaks or becomes disconnected from the spool that holds the webbing, the seat belt may not retract properly. Is your seat belt stuck or not retracting properly? Discover common causes and easy DIY fixes to stay safe and save money.
I did a search, and was amazed to find only one six-year-old thread on this, which didn't find a resolution. The seat belt on the passenger side of my daughter's 04 325i has suddenly stopped retracting. This causes it to fit very loosely, rendering it essentially useless.
Has anyone had this problem, and is there a solution, short of replacing the interial reel? Thanks.