Maintain your plants, pets, and family members well hydrated during hot days or busy schedules with a homemade automatic water dispenser. This hands-on guide will walk you through creating this essential piece of home equipment using simple materials.

Before you start, ensure you have all the necessary supplies and tools. You'll need a large plastic bottle, a marquee craft knife, tape, water tubing (aquarium varieties work best), a drill with a small bit, a sharp needle, and a marker pen.

Designing and Preparing Your Bottle
Start by carefully drawing your design on the bottle. The design should include two holes - one for water inlet and one for outlet. Make sure they're positioned precisely to avoid leaks.

Drill into the bottle gently at the marked points. It might take a few twists to pierce the plastic. Once done, clean the bottle and the holes thoroughly to ensure no plastic residue remains.
Creating the Inlet Hole

Mark the hole's center and create a small notch using the marquee craft knife. This will help prevent the plastic from cracking when you drill.
Slowly and carefully drill through the bottle's side. Do not drill completely through the first time. If the bottle becomes blocked, stop and clear it with the needle. Once done, gradually widen the hole using larger drill bits.
Creating the Outlet Hole

Follow the same process as above, but this time, the hole should be slightly larger for the water tubing. Ensure it's large enough for your chosen tubing to fit snugly.
After enlarging the hole, make sure the tubing fits perfectly. If it's too loose, you may need to widen the hole or adjust your tubing. Remember to take your time during this process to avoid cracks or leaks.
Preparing the Tubing

Before attaching the tubing, ensure you've selected the right size for your bottle's outlet hole. The tubing should fit snugly, without being too loose or tight.
Measure and cut your tubing to the desired length, usually based on where you want your water dispenser to be placed. Make sure to leave enough extra length to control the dispenser.









Securing the Tube
Thread the tubing through the outlet hole, ensure it's well-fitted, and secure it in place with tape. If the hole is too large for the tubing, you can use a rubber O-ring or a small cloth between the tubing and the bottle to prevent leaks.
Make sure the tubing is securely fastened, with no risk of coming off or moving around too much. This will help ensure your automatic water dispenser functions correctly.
Testing Your Automatic Water Dispenser
Fill your bottle with water and place it at the desired height. The higher you place the bottle, the more pressure you'll put on the water, resulting in a faster flow.
Observe how the water flows out of the tubing. If it's too slow, try raising the bottle. Conversely, if it's too fast, lower it slightly. Once you've found the perfect height, secure the bottle in place to prevent it from wobbling or tilting.
Congratulations! You've just created a homemade automatic water dispenser. This simple device can save you time, prevent dehydration, and keep your plants and pets well-watered. Consider decorating your bottle or painting it to match your home's decor.