Accurate measurement is the foundational step to a perfectly functioning kitchen, and when it comes to Blum undermount drawer slides, precision is non-negotiable. A single millimeter off can result in a drawer that is difficult to open, wobbles dangerously, or fails to clear the face frame entirely. This process requires a blend of the right tools, a clear understanding of Blum’s specific system requirements, and a methodical approach to measuring your cabinet box.
Understanding Blum Undermount Slide Systems
Before taking a tape measure, it is essential to understand that Blum undermount slides are not a one-size-fits-all solution. They operate on specific mechanical systems, most commonly the "System 110" or "Touch Development" (TD) lines, which dictate the installation dimensions. Unlike side-mounted slides, undermount slides are mounted on the bottom of the drawer box and the cabinet floor, meaning the available space inside the cabinet and the drawer box depth are critical constraints. You must account for the slide mechanism itself, which protrudes beneath the drawer, and the necessary clearance for the drawer front to clear the slide during operation.
Gathering Your Tools
Preparation is key to avoiding errors, so assemble your toolkit before you begin. You will need a reliable tape measure, a straightedge or level, a pencil for marking, and ideally a digital caliper for measuring thin gaps with high accuracy. A scrap piece of wood can serve as a spacer, and a smartphone with a flashlight can be helpful for seeing into deep cabinet boxes. Having these items ready ensures you can take consistent, repeatable measurements without interruption.

Step-by-Step Measurement Process
The process begins by measuring the interior width of your cabinet opening at the precise location where the drawer will sit. Use the top, middle, and bottom points to account for any imperfections in the cabinet construction; always use the smallest of these three measurements to ensure the drawer will fit. Next, measure the depth of the cabinet from the front edge to the back wall, subtracting a minimum of 2 to 3 inches to provide clearance for the undermount slide hardware and the drawer face. This adjusted depth determines the maximum length your drawer box can be.
| Measurement Category | What to Measure | Blum-Specific Adjustment |
| Width | Interior cabinet opening (top, middle, bottom) | Use the smallest measurement; no subtraction needed for the slide mechanism. |
| Depth | Cabinet inner depth front to back | Subtract 2 to 3 inches for slide hardware and face frame clearance. |
| Height | Distance from drawer bottom to desired drawer front location | Subtract the slide thickness (approx. 1/2") from the opening height. |
Accounting for the Drawer Front
One of the most common mistakes is forgetting that the drawer front is not part of the box. When using undermount slides, the slide hardware must be mounted to the very bottom of the raw drawer box. You then position the drawer front to the desired location (usually 1/2" overlap on top and sides) and attach it to the box. Therefore, your measurement for the height of the drawer box itself should be the distance from the bottom of the drawer opening to the underside of the drawer front, minus approximately 1/2 inch for the slide thickness and any necessary clearance.
Verifying Slide Compatibility and Placement
With your cabinet measurements complete, you must cross-reference them with the specific Blum slide model you intend to purchase. For example, a standard "110-50" slide indicates it is a half-overlay slide with a 50cm drawer width and specific inner height limitations. Check the product datasheet for the minimum and maximum cabinet dimensions. Furthermore, confirm the required "reveal" – the gap between the drawer front and the cabinet front – typically 1/8" to 1/4", which ensures smooth operation and prevents the drawer from binding against the cabinet frame.

Final Checks and Installation Tips
Prior to cutting your drawer wood, perform a dry run by holding the prepared drawer box inside the cabinet with a spacer underneath to simulate the slide position. This allows you to verify that the drawer front will clear the cabinet hinge pins and any kickboard obstructions. When you are ready to install the slides, remember that consistency is critical; both slides must be mounted at the exact same height and depth to prevent the drawer from tilting. Using Blum's proprietary measuring gauges, if available, can transform these measurements into a foolproof installation, ensuring the smooth, silent operation the brand is known for.























