Printables Drain Snake

With everyone staying at home your drains might be getting clogged more quickly. You can't call anyone to take care of it and you can't go out to buy a drain cleaning tool or chemicals, so why not print your own!? This 8.5" drain snake will clean out your drains quickly and easily. Print instructions Prints flat with a brim.

I printed this in ABS, but PLA may work as well. There are few things I hate more than a clogged drain, especially in a tub/shower set up. So, here's the solution to my problems the same as yours!

This is super flexible but strong 5gram PLA print for the largest drain snake you can make on an A1 printer. You can resize it however you like, it works well even at 50%, so it can easily fit on an the A1 mini. Enjoy a clean sink/shower drain.

Remove hair and other debris from your sinks plumbing with this quick and effective print. The EZPZ Drain Snake prints in a coil to fit on more printers. Soften the print with a heat gun or hairdryer to uncoil it, and then it's ready to use!

There are plenty of drain snake STLs out there, but this one has bite. The design allows larger teeth while keeping the snake small enough to slip into drains. Prints in less than 30 minutes and works well at 0.20mm layer height.

Fun facts: When printed, this tool is just under 20cm Prints great on Prusa MK3S and Prusa Mini I recommend PETG or other "less brittle" filament No brim needed for. Just print it and put it in a bowl of boiling water to straighten it out. Overall length is 16".

Here is a 3D printable drain snake. This tool allows you to clean out all the gunk that gets stuck/caught in the drain. The whole idea is instead of spending a lot of money on a store bought drain snake, you can print this snake yourself for a few cents and then throw it away after you use it.

I make 2 different sizes. Versatile drain cleaning tool available in three lengths-15cm, 20cm, and 25cm-designed to effectively unclog and remove hair and stubborn debris from (drain) pipes. Works with most filament types, provided they aren't overly flexible or brittle.

A 0.4mm nozzle is recommended for optimal results. Each print uses about 2.5 to 3.5 grams of filament (*depending on the size) and is ready to. It's 60mm longer than the original, fits on MK3's bed diagonally.

Download free 3D printable STL models. This drain snake is based off of my original model, but I made the burs significantly longer to help grab the hair that is in the drain. PLEASE NOTE: you need to have a drain opening that is greater than 4x12mm in order for this snake to fit in your drain.

I also HIGHLY recomment you print this out of PETG.