How to Configure NAT on Cisco Router Step by Step

Basically NAT allows a single network device (e.g a router , firewall etc) to act as an agent between a private local area network and a public network such as the Internet. The purpose of this NAT device is to translate the source IP addresses of the internal network hosts into public routable IP addresses in order to communicate with the Internet.

This document describes how to configure the Network Address Translation ( NAT ) on a Cisco router .
How to Configure Static NAT on Cisco Routers

This tutorial explains how to configure , test, and verify static NAT through an example .
This guide shows how to configure NAT and PAT in all three forms a Cisco router supports, static NAT , dynamic NAT with a pool, and Port Address Translation, on a real lab, then reads the resulting translation table. NAT sits on the boundary router or firewall, the device with one foot in the private network and one foot in the public internet.

Cisco NAT Configuration
The first step to configuring NAT on any Cisco IOS router is designating which interfaces should be considered " Inside " and which should be considered " Outside ". It is easy to look at a network topology diagram to determine which interfaces are facing the Internet and which interfaces are facing the internal servers.
What is NAT and why is it important to configure it on a Cisco router ? NAT , which means Network Address Translation, is a process that allows a router to change the IP address of a data packet as it travels through a network.

Static NAT
This article describes how to configure static NAT (Network Address Translation) on a Cisco IOS router using an example .
The NAT Route Maps Outside- to -Inside Support feature enables you to configure a Network Address Translation ( NAT ) route map configuration. It allows IP sessions to be initiated from the outside to the inside.

Static NAT Configuration in Cisco
A router with an interface on the local (internal) network and an interface on the global (external) network. When a packet leaves the local (internal) network, NAT translates its local (private) IP address to a global (public) IP address.









Here are the basic configuration on implementing different types of Network Address Translation ( NAT ) on Cisco Routers . Fig.1 Static NAT (1-to-1 Translation) (Objective: to translate PC-1 private IP of 192.168..2 to public IP 200.200.200.3) Configuration: Router1 Main Static NAT configuration: ip nat inside source static <Inside local IP> <Inside global IP> Sample Config: Router1 (config)# ip ...