Locating the sensor de temperatura in your Toyota 22R engine is the first step towards diagnosing performance issues or performing a routine replacement. This specific component, often referred to as the Coolant Temperature Sensor (CTS), plays a critical role in the vehicle's management system. Understanding its precise location helps owners and mechanics ensure the engine runs at optimal temperature, directly impacting fuel efficiency, emissions, and overall longevity.
Identifying the 22R Engine Family
The Toyota 22R series was a staple in Toyota's lineup for decades, powering everything from Hilux pickups to Land Cruisers. Before diving into the specifics, it is important to confirm you are working with a 22R engine. This 2.4-liter inline-four was known for its durability and mechanical simplicity. The sensor location remains relatively consistent across the years, but variations between the 22R, 22R-E (electronic fuel injection), and the diesel 22D can exist, making initial verification essential.
Primary Location: Thermostat Housing
The most common location for the sensor de temperatura on a Toyota 22R is on the front of the engine, near the top. Specifically, you will find it embedded in or very close to the thermostat housing. This position is strategic, as it allows the sensor to read the temperature of the coolant immediately after it exits the engine block, providing the most accurate reading for the vehicle's computer. Accessing it usually requires working in the engine bay, near the intake manifold.

Step-by-Step Visual Identification
- Open the hood and locate the thermostat cover, a metal piece bolted to the end of the upper radiator hose.
- Look for a small electrical connector protruding from the metal housing.
- The sensor itself is a cylindrical metal probe threaded into the casting, typically featuring a single wire harness.
- You will usually find it on the passenger side of the engine, facing slightly inward.
Secondary Location: Intake Manifold Runner
In some configurations of the 22R, particularly in later years or specific applications, the temperature sensor may be located on the side of the intake manifold. If you cannot find a sensor near the thermostat housing, check the runner that leads to the throttle body. This location is slightly more difficult to access, as it often requires removing air intake components to view the back of the manifold.
The Role of the Temperature Sensor
Physically locating the sensor is only half the battle; understanding its function explains why it is so vital. The sensor de temperatura acts as the eyes for the Engine Control Unit (ECU). It relays the real-time temperature of the coolant back to the computer. The ECU uses this data to adjust the fuel injection timing, ignition timing, and fan activation. A faulty sensor can cause cold-start difficulties, poor fuel economy, or the engine running too hot or too cold.
Common Failure Symptoms
When the sensor de temperatura begins to fail, the vehicle will often communicate the issue through dashboard warnings or performance anomalies. Look out for the following signs that indicate the sensor or its wiring may need attention:

- The dashboard temperature gauge reads consistently cold or hot.
- The check engine light illuminates, often storing a diagnostic trouble code (DTC) related to the coolant temperature.
- Increased fuel consumption or rough idling.
- Difficulty starting the engine when cold, as the ECU miscalculates the fuel mixture.
Replacement and Safety Considerations
Replacing the sensor on a Toyota 22R is a task accessible to DIY enthusiasts, but it requires specific precautions. Because the sensor is integrated into the thermostat housing or intake runner, draining the coolant is usually necessary to prevent a messy spill. Always ensure the engine is completely cool before beginning this procedure. Using the correct socket size to remove the sensor is crucial, as the surrounding components can be brittle and break if forced. When installing the new sensor, be careful not to overtighten the threads, as this can strip the housing and lead to future coolant leaks.
| Symptom | Possible Cause | Location Hint |
| Engine overheating | Faulty sensor or wiring | Front of engine, near thermostat |
| Poor fuel economy | Stuck open/closed sensor | Intake manifold runner |
| Hard cold start | Incorrect resistance signal | Thermostat housing area |






















