Hyundai Equus Jack Points

This is a guide on how to jack up your car properly. A Jack ALWAYS put your vehicle in gear and lock your E-brake when jacking your vehicle up, and use jack stands. Photos of the jacking points Pictures explaining how to jack up your car with a floor jack Note: You should use jack stands in pairs and never go further then 2 clicks from the end.

Always use the steel re. The only approved jacking points are the four shown in the diagram. Hyundai does not recommend any other places, so if you try there it may work, or you may bend a frame or suspension part.

View, print and download for free: jack points - Hyundai Equus 2011 Owner's Manual, 385 Pages, PDF Size: 10.67 MB. Search in Hyundai Equus 2011 Owner's Manual online. The front subframe and rear crossmember are recommended as valid lift points by Hyundai if you've got a hydraulic floor jack.

They've got a document on hyundaitechinfo.com called "Lift Points and Precautions for Lift" that you can download that shows the best lift points and procedures for various types of lifts. Jack label Model Name Maximum allowable load Always apply the parking brake before using a jack. Always turn off the engine before using a jack.

Never put any portion of your body under the vehicle supported by a jack. Only use the designated jacking locations on the frame. When supporting the vehicle, have the base plate of the jack flat on the ground under the lifting point.

Shift the gear. View and Download Hyundai 2011 EQUUS quick reference manual online. 2011 EQUUS.

2011 EQUUS automobile pdf manual download. The Factory Lift/Jack points as outlined in the manual vary from the rest of the seam only in the little "notches" that Hyundai put to indicate those areas. Where you point out seems to be an acceptable area as well, if only a little harder to get at.

The pinch weld adapters don't work well for Hyundai - at least the RB Accent - the inbord support is higher than the outboard section near the pinch weld. But a good floor jack with a large saddle works fine. I rarely take all four wheels off the ground (actually, I only have two jack stands), but if I wanted to: Jack left rear at jack point.

I picked up a harbor freight super duty (yellow) jack to start doing my oil changes. This jack has a flat, 5" lift pedestal. My question is what are you using to lift the car up since we have both pinch welds and unibody restriction? I've seen a video of lifting at the proper location and.

The only places approved by Hyundai for supporting the car are the pinch-weld locations. The only way to jack and support the car for doing brake work is to use a combination jack/stand like the Unijack.