Shimming a Prehung Door: A Comprehensive Guide

Ever noticed that your prehung door is rubbing against the frame, making it difficult to close or causing unwanted drafts? This is often due to misalignment, which can be easily rectified by shimming the door. Shimming involves inserting thin pieces of material, usually wood or plastic, between the door and the frame to adjust the fit. In this guide, we'll walk you through the process of shimming a prehung door, ensuring a perfect fit and optimal functionality.

Understanding Your Door and Frame
Before you start, it's crucial to understand the components of your prehung door. A prehung door comes with the frame already attached, and it's this frame that you'll be working with. The frame consists of the top and bottom plates, and the two side jambs. The door itself is hung on hinges that are attached to the side jambs.

Gathering Your Tools and Materials
To shim a prehung door, you'll need the following tools and materials:

- Tape measure
- Craft knife or utility knife
- Ruler or straight edge
- Shims (wood or plastic, 1/8" to 1/4" thick)
- Pencil
- Hammer
- Screwdriver (if your door has adjustable hinges)
Measuring for Shims
Start by measuring the gaps between the door and the frame. You want to ensure that the door is centered in the frame and that the gaps are even on all sides. Use your tape measure to check the gaps at the top, bottom, and both sides of the door.

Marking and Cutting Shims
Once you've measured the gaps, mark the shims to the appropriate size. Most shims come in standard sizes, but you may need to cut them down to fit your specific gaps. Use a craft knife or utility knife and a straight edge to cut the shims to size. Remember, it's easier to cut off too little than too much, so err on the side of caution.
Installing the Shims

Now it's time to install the shims. Start at the top of the door and work your way down. Here's how to install shims on each part of the door:
Top of the Door




















If the gap at the top of the door is uneven, you'll need to install shims on both sides. Mark the shims, cut them to size, and tap them into place with a hammer. If the gap is even, you'll only need to install shims on one side.
Sides of the Door
Install shims on the sides of the door by tapping them into place with a hammer. If your door has adjustable hinges, you may be able to adjust the hinges to eliminate the need for shims. Consult your door's instructions for more information.
Bottom of the Door
The bottom of the door is a bit trickier because it has to accommodate the sweep of the door. You'll need to install shims on both sides of the door, and you may need to install them at an angle to match the sweep. Use a pencil to mark the angle on the shim, then cut it to size and tap it into place.
Testing Your Door
Once you've installed all the shims, test your door to ensure it's functioning properly. Open and close the door several times to make sure it's not rubbing against the frame. If it is, you may need to adjust the shims or install additional ones.
Finishing Up
If your door is functioning properly, you're all done! If not, don't despair. Shimming a prehung door can take a bit of trial and error, but with patience and careful measurement, you can achieve a perfect fit. And remember, if you're ever in doubt, don't hesitate to consult a professional.