Painting Over High Gloss Lacquer: A Comprehensive Guide
High gloss lacquer can be a challenge to paint over due to its smooth, slippery surface. However, with the right preparation and techniques, you can achieve a successful paint job. This guide will walk you through the process, ensuring your project turns out flawless and professional.
Understanding High Gloss Lacquer
High gloss lacquer is a durable, shiny finish often used on furniture and cabinets. Its smooth, glossy surface makes it resistant to paint adhesion. To paint over it, you'll need to create a better surface for the paint to grip onto.
Materials Needed
- Sanding sponge or sandpaper (220-grit)
- Tack cloth or damp cloth
- Primer (shellac-based or oil-based)
- Paint (latex or oil-based)
- Paintbrushes or rollers
- Drop cloth
- Safety gear (gloves, goggles, mask)
Preparation
Before you start, ensure the surface is clean and free of dust. Remove any hardware, cover the floor with a drop cloth, and wear appropriate safety gear.

Step 1: Lightly Sand the Surface
Use a sanding sponge or sandpaper to lightly sand the surface. This helps to create a better surface for the paint to adhere to and reduces the gloss. Be careful not to sand too hard, as this can damage the lacquer.
Step 2: Clean the Surface
After sanding, use a tack cloth or a damp cloth to wipe away any dust. Allow the surface to dry completely before moving on to the next step.
Step 3: Apply Primer
Primer is crucial when painting over high gloss lacquer. It helps to seal the surface, promote paint adhesion, and prevent tannin bleed (where the wood's natural oils seep through the paint). Use a shellac-based or oil-based primer, applying it evenly with a brush or roller. Allow it to dry according to the manufacturer's instructions.

Step 4: Lightly Sand the Primed Surface
Once the primer is dry, lightly sand the surface again using a fine-grit sandpaper. This helps to smooth out any raised grain and ensures a smooth finish. Wipe away any dust with a tack cloth.
Step 5: Paint the Surface
Now you're ready to paint. Use a latex or oil-based paint, applying it evenly with a brush or roller. Work in small sections, applying thin, even coats. Allow each coat to dry completely before sanding lightly and applying the next coat. Most surfaces will require 2-3 coats.
Step 6: Allow the Paint to Cure
After the final coat, allow the paint to cure for at least 24 hours before lightly sanding and applying a clear topcoat if desired. This ensures the paint is fully dry and ready for use.

Troubleshooting Common Issues
| Issue | Solution |
|---|---|
| Paint not adhering | Ensure you've primed the surface properly and allowed adequate drying time between coats. |
| Brush marks or roller lines | Use a high-quality brush or roller and apply thin, even coats. Sand lightly between coats to smooth out any imperfections. |
| Tannin bleed | Use a shellac-based primer to seal the surface and prevent tannin bleed. |
Painting over high gloss lacquer can be a rewarding project with the right preparation and techniques. By following this guide, you'll achieve a professional, long-lasting finish that you'll be proud to show off.






















