As a homeowner, protecting your roof is crucial to maintain your home's integrity and value. Ice and water shield, a self-adhesive membrane, is a vital barrier that prevents water intrusion, ice dams, and melting snow from causing damage. Proper placement is key to ensuring its effectiveness. Here's a comprehensive guide on where to put ice and water shield on your roof.

First, let's understand the purpose of an ice and water shield. It's designed to protect the most vulnerable areas of your roof, especially the lower 36 inches from the eaves, where ice dams are most likely to form. It also seals around vents, skylights, and chimneys, creating a strong barrier against moisture.

Key Roof Zones for Ice and Water Shield Application
The first step is identifying the critical areas on your roof where ice and water shield should be applied. These include:

Eaves and Edges: The lower 36 inches of your roof, where melting snow and ice often refreeze and create dams, causing leakage.
Vents, Skylights, and Chimneys: These openings create potential weak points that can be exploited by water intrusions. Sealing these areas with ice and water shield is essential.

Proper Placement Along Eaves and Edges
Applying ice and water shield along eaves and edges is a two-step process. First, start at the outer edge of the eave, overlapping each new strip by about 6 inches. This ensures a continuous barrier and allows water to flow harmlessly into the gutter.
Second, extend the shield upwards for at least 36 inches. This ensures protection against ice dams. Remember, it's better to apply more shield than less. Always follow the manufacturer's guidelines for the specific product you're using.

Sealing Vents, Skylights, and Chimneys
To create a watertight seal around penetrations, start by measuring and cutting the ice and water shield to the appropriate size. Apply it with the sticky side down, pressing firmly and ensuring it sticks well to the roof.
For vents, apply the shield a few inches past the vent outlet. For skylights and chimneys, extend the shield under the Flashing (the material that redirects water away from the penetration) and up the sides for additional protection.

More Application Tips and Best Practices
While knowing where to put ice and water shield is crucial, how you apply it is equally important.









Overlap Properly: Always overlap strips by at least 6 inches. Thisbials overlapping creates a ladder effect, allowing water to weep down and away from the roof.
Dealing with Valleys
Roof valleys are prominent water channels that direct water into the gutter. Apply ice and water shield on both sides of the valley, extending it up the roof slope and under any overlapping shingles.
Also, ensure the shield overlaps the drip edge at the bottom of the valley. This prevents water from seeping under the shingles and causing damage to your roof's interior.
Applying Ice and Water Shield During Re-roofing
When re-roofing, calculate the amount of ice and water shield you'll need based on the total roof area. Remove any old felt or underlayment, ensuring the roof surface is clean and dry before application.
Then, apply the shield following the steps outlined above. It's crucial to reinstall new drip edges after the shield has been applied.
Finally, always ensure you're following local building codes and manufacturer's guidelines. A poorly applied ice and water shield, even with optimal placement, could lead to more damages than good. Consider hiring a professional roofer if you're unsure about any part of the installation process. Regular inspections can also help ensure your roof stays in top shape.