Removing old linoleum tile is a necessary step for any serious home renovation or flooring replacement project. Whether you are updating the kitchen, bathroom, or entire living area, the process of how to get up linoleum tile requires the right preparation and technique. This guide provides a detailed, step-by-step methodology to ensure the removal is efficient, safe, and successful, minimizing damage to the subfloor.
Preparing for Linoleum Removal
Before applying any heat or scraper, preparation is the most critical phase of removing linoleum. A clear workspace and proper personal protection will make the entire process smoother and safer. You should begin by clearing the room of all furniture and debris, creating an open area to work comfortably.
Next, address the safety concerns associated with older installations. Linoleum installed before the 1980s may contain asbestos, a hazardous material that requires professional handling. If you suspect asbestos, stop immediately and contact an abatement specialist. For standard removal, ensure you wear heavy-duty gloves, safety goggles to protect from debris, and a dust mask to avoid inhaling fine particles.

Tools and Materials Needed
Gathering the correct tools is essential for efficiency. You will need a utility knife with fresh blades, a sturdy pry bar, a hammer, a heat gun or steam scraper, and a wide putty knife. For cleanup, have a shop vacuum, a large bucket, and a mop ready. Applying a chemical adhesive remover can also save significant time if the glue is stubborn.
Below is a quick reference table for the essential tools required for the job:
| Tool | Purpose |
|---|---|
| Heat Gun or Steamer | Softens the adhesive backing |
| Utility Knife | Cuts the tile into sections |
| Pry Bar & Hammer | Lifts and removes the pieces |
| Putty Knife | Scrapes residual adhesive |
The Physical Removal Process
The actual removal of the tile should be approached methodically to avoid damaging the subfloor, which is usually plywood or concrete. Begin by using a utility knife to score the seam where the linoleum meets the wall. This allows the material to curl up cleanly without pulling on the subfloor.

For large areas, cutting the tile into manageable sections is highly recommended. Measure and mark straight lines across the floor, cutting through the tile to create smaller pieces. This prevents the material from folding over on itself and makes the lifting process significantly less cumbersome.
Utilizing Heat
If the linoleum is particularly old and tough to lift, heat is the most effective solution. Using a heat gun, apply steady heat to the surface of a small section. The warmth activates the old adhesive, making the material pliable. Once the floor feels warm and soft, use a putty knife to gently lift the corner and peel the section away. Work slowly to avoid tearing the material, which can make cleanup more difficult.
For those who prefer a non-flame method, a steam scraper is an excellent alternative. These devices use hot steam to penetrate the adhesive without the risk of fire. The heat breaks down the bond quickly, allowing for easy scraping. Regardless of the method, it is usually necessary to apply heat or steam to small sections at a time to keep the material flexible.

Cleaning the Subfloor
Once the linoleum is removed, the work is not yet complete. The next phase involves cleaning the subfloor to prepare it for new installation or finishing. You will likely encounter residual glue, small shards of tile, and ground-in dirt that must be addressed.
Start by sweeping or vacuuming the entire area to remove loose debris. For glue removal, apply a citrus-based or soy-based adhesive remover to the surface. Allow the solution to sit for the time specified by the manufacturer, which will break down the sticky residue. Use a stiff scrub brush or a scraper to agitate the surface until it is clean and smooth.
Finally, rinse the floor thoroughly with water and allow it to dry completely. Moisture can compromise the integrity of new flooring, so ensuring the subfloor is bone dry is the final, vital step before proceeding with your next renovation phase.






















