A perfectly level pool table is the foundation of consistent and fair gameplay. Even a slight deviation of a few degrees can cause balls to roll off course, turning a precise shot into a frustrating miss. The primary cause of this instability is often uneven floor elevation or worn adjustable feet, making the ability to level pool table legs an essential skill for any serious player or owner.
The process itself is methodical, relying on patience and the right tools rather than brute force. It transforms a potentially guesswork-heavy task into a precise science, ensuring the playing surface is geometrically perfect from corner to corner. Mastering this adjustment not only improves your game but also protects the integrity of the table's bed and rails over the long term.
Gathering the Necessary Tools
Before beginning, preparation is key. Rushing the process with inadequate tools will only lead to frustration and inaccurate results. Having the correct equipment on hand ensures a smooth and efficient leveling procedure.

- A reliable level, ideally two: a standard torpedo level for the frame and a long spirit level (at least 36 inches) for the playing surface.
- Wrenches that match the size of your leveling feet, which are often custom or specialty sizes.
- A thick, rigid playing card or a specialized table shim kit for bridging large gaps.
- A flashlight to inspect dark corners and a notepad to record your adjustments.
Initial Assessment and Preparation
Start by clearing the table of its slate and felt cover, exposing the intricate framework below. This provides an unobstructed view of the legs and their connection points. Next, place the shorter level on each leg vertically to check for any significant plumb, ensuring the table is not leaning dangerously to one side.
With the vertical check complete, position the long spirit level across the width and then the length of the table. Note the specific leg where the bubble is furthest from the center. Identify whether the table is high or low at that point; this initial diagnosis guides your subsequent actions and prevents unnecessary adjustments.
Adjusting the Legs Systematically
Most modern pool tables feature adjustable feet with a threaded bolt design. The fundamental principle is simple: turning the bolt clockwise typically raises that specific corner, while turning it counter-clockwise lowers it. However, the true art lies in the systematic approach to these adjustments.

Focus on one leg at a time. Make a small quarter-turn increment and recheck the level. Observe how the bubble shifts across the vial. This incremental method prevents over-correction, which is a common mistake that leads to a back-and-forth cycle of adjustments. Patience is your most valuable tool in achieving a perfectly balanced table.
Dealing with Uneven Floors and Large Gaps
Not all instability is caused by the table itself; sometimes the floor is the culprit. If a leg has been turned completely without effect, you may be encountering a case where the floor is lower than the surrounding foundation. In these scenarios, shimming becomes a necessary solution to bridge the gap.
Insert a thin, rigid playing card or a commercial shim material underneath the leg and into the gap between the leg and the floor. Add material incrementally—two or three cards at a time—while constantly rechecking the level. The goal is to build up the foundation beneath the leg until it sits stable and level, locking the table securely in place.

Verification and Fine-Tuning
Once all four legs are adjusted and the main bubble on the level is centered, the work is not yet finished. A comprehensive verification process is required to ensure the entire plane of the slate is level, not just the individual legs. Place the level diagonally across the table, from one corner pocket to the opposite corner.
Repeat this for both diagonal directions. If the bubble remains centered in all four positions, your table is perfectly level. If discrepancies persist, return to the leg that appears highest and make minute adjustments, understanding that lowering one corner often affects the adjacent corner. This final fine-tuning is what separates a good setup from a professionally tuned machine.






















