Installing an ice and water shield, such as the one provided by Owens Corning, is a crucial step in ensuring the longevity and water resistance of your roof. This sophisticated underlayment acts as a secondary barrier to protect your home from water infiltration and ice dams. Follow these comprehensive, step-by-step instructions to ensure a proper and effective installation.

Before we dive into the installation process, it's essential to understand that Owens Corning's ice and water shield is designed to be installed on sloped roofs. It's critical to ensure your roof has a minimum slope of 2/12 to facilitate water runoff and prevent standing water on the shield.

Preparation and Materials
Before you begin, gather your materials and ensure your work area is clean and safe. You'll need the following:

- Owens Corning ice and water shield
- Rolls of roofing felt (15 or 30 lb)
- Roofing nails (galvanized or stainless steel)
- Utility knife
- Tape measure
- Hammer or nail gun
- Chalk line
Inspect your roof and ensure it's clean and free of any debris or old materials that could damage the ice and water shield during installation.

Estimating Material Needs
To ensure you have enough material, measure the length of your roof's eaves and the length and width of your valleys. Add 6 inches to both eaves and valleys measurements for proper overhang. For example, if your eaves are 20 feet long, you'll need 26 feet of ice and water shield.
Calculate the total square footage of your roof, and divide it by the square footage covered by one roll of Owens Corning ice and water shield to determine how many rolls you'll need.

Installation Process
Now that you've prepared your roof and gathered your materials, you're ready to install the Owens Corning ice and water shield.
Installing Around Eaves

The first step is to install the ice and water shield around your roof's eaves. Begin at the bottom edge of the eave, overlapping each row by 6 inches. Secure the shield to the roof using roofing nails, spaced no more than 6 inches apart along the edges and 12 inches apart in the field.
Use a utility knife to trim the shield around any vents or obstacles, ensuring a snug fit and preventing any water from seeping underneath. Always extend the shield at least 24 inches up the roof slope from the eaves.








Installing in Valleys and Along Rafters
Next, install the ice and water shield in your roof's valleys and along the rafters. Begin at the lowest point of the valley, overlapping each row by 6 inches. Secure the shield using roofing nails, following the same spacing as before.
Continue installing the shield along the rafters, extending it at least 24 inches up the roof slope from the rafter edge. Be sure to securely nail the shield every 6 inches along the rafter's edge and every 12 inches in the field.
Installing Along Ridge and Other Unique Features
Install the shield along your roof's ridge, overlapping each row by 6 inches. Secure it with roofing nails, following the standard spacing. At pornches, dormers, and other unique architectural features, install the shield first, then install the porch roof or dormer roofing as usual.
Always follow the manufacturer's guidelines and local building codes to ensure a proper and safe installation.
Finishing Up
After you've installed the Owens Corning ice and water shield on your entire roof, it's time to finish up and inspect your work.
Inspect for Leaks and Tears
Carefully inspect the entire ice and water shield installation for any leaks, tears, or improperly installed sections. Repair any issues immediately to ensure your roof remains watertight.
Once you're satisfied with the installation, proceed with installing the rest of your roofing materials, following the manufacturer's guidelines for proper overlapping and securing principles.
Installing an ice and water shield is an essential step in ensuring your roof's longevity and protecting your home from water damage. Regularly inspect your roof and keep an eye on the ice and water shield to maintain its effectiveness and extend its lifespan.