Route
Specifies a route in a route table. For more information, see Routes in the Amazon VPC User Guide. You must specify either a destination CIDR block or prefix list ID. You must also specify exactly one of the resources as the target. If you create a route that references a transit gateway in the same template where you create the transit gateway, you must declare a dependency on the transit gateway attachment. The route table cannot use the transit gateway until it has successfully attached to the VPC. Add a DependsOn Attribute in the `AWS::EC2::Route` resource to explicitly declare a dependency on the `AWS::EC2::TransitGatewayAttachment` resource.
Properties
The ID of the carrier gateway. You can only use this option when the VPC contains a subnet which is associated with a Wavelength Zone.
The Amazon Resource Name (ARN) of the core network.
The IPv4 CIDR address block used for the destination match. Routing decisions are based on the most specific match. We modify the specified CIDR block to its canonical form; for example, if you specify `100.68.0.18/18`, we modify it to `100.68.0.0/18`.
The IPv6 CIDR block used for the destination match. Routing decisions are based on the most specific match.
The ID of a prefix list used for the destination match.
IPv6 traffic only The ID of an egress-only internet gateway.
The ID of a NAT instance in your VPC. The operation fails if you specify an instance ID unless exactly one network interface is attached.
The ID of the local gateway.
IPv4 traffic only The ID of a NAT gateway.
The ID of a network interface.
The ID of the route table for the route.
The ID of a transit gateway.
The ID of a VPC endpoint. Supported for Gateway Load Balancer endpoints only.
The ID of a VPC peering connection.