Job
Constructors
Properties
Any of the host devices to expose to the container. This parameter maps to Devices in the Create a container section of the Docker Remote API and the --device option to docker run .
If true, run an init process inside the container that forwards signals and reaps processes. This parameter maps to the --init option to docker run . This parameter requires version 1.25 of the Docker Remote API or greater on your container instance. To check the Docker Remote API version on your container instance, log in to your container instance and run the following command: sudo docker version | grep "Server API version"
The total amount of swap memory (in MiB) a container can use. This parameter is translated to the --memory-swap option to docker run where the value is the sum of the container memory plus the maxSwap value. For more information, see --memory-swap details in the Docker documentation. If a maxSwap value of 0 is specified, the container doesn't use swap. Accepted values are 0 or any positive integer. If the maxSwap parameter is omitted, the container doesn't use the swap configuration for the container instance on which it runs. A maxSwap value must be set for the swappiness parameter to be used.
The value for the size (in MiB) of the /dev/shm volume. This parameter maps to the --shm-size option to docker run .
You can use this parameter to tune a container's memory swappiness behavior. A swappiness value of 0 causes swapping to not occur unless absolutely necessary. A swappiness value of 100 causes pages to be swapped aggressively. Valid values are whole numbers between 0 and 100 . If the swappiness parameter isn't specified, a default value of 60 is used. If a value isn't specified for maxSwap , then this parameter is ignored. If maxSwap is set to 0, the container doesn't use swap. This parameter maps to the --memory-swappiness option to docker run . Consider the following when you use a per-container swap configuration.
The container path, mount options, and size (in MiB) of the tmpfs mount. This parameter maps to the --tmpfs option to docker run .