Replacing Fabric on Your Sunsetter Awning: A Step-by-Step Guide

Your Sunsetter awning has been a faithful companion, providing shade and comfort for years. However, like all things, its fabric eventually wears out and needs replacing. Don't worry, this isn't a task for a professional only. With the right tools and a bit of patience, you can replace the fabric on your Sunsetter awning yourself. Here's a comprehensive, step-by-step guide to help you through the process.

Tools You'll Need
- New awning fabric (ensure it matches your awning's size and type)
- Screwdriver (Philips or flathead, depending on your awning's screws)
- Scissors or utility knife
- Tape measure
- Pencil
- Hammer (optional, for tapping out stubborn screws)

Preparation: Measuring and Ordering New Fabric
Before you start, you'll need to measure your awning to order the correct replacement fabric. Here's how:

- Measure the width of your awning from one side to the other.
- Measure the length of your awning from the top (where it attaches to the house) to the bottom.
- Order your new fabric, adding a few inches to each measurement for overlap and error.
Removing the Old Fabric
Now that you have your new fabric, it's time to remove the old one. Here's how:

- Start by removing the screws that hold the fabric in place. Use a screwdriver to do this, and if the screws are being stubborn, you can use a hammer to gently tap them out.
- Once all the screws are out, carefully remove the old fabric. It might be in pieces due to wear and tear, so be cautious not to damage the awning frame.
Installing the New Fabric
With the old fabric gone, it's time to install the new one. Here's how:

- Lay out your new fabric and ensure it's the correct size. If it's not, trim it to fit using scissors or a utility knife.
- Starting at one end, carefully attach the new fabric to the awning frame using the screws you removed earlier. Make sure to leave a few inches of overlap at the top and sides.
- Once the fabric is securely attached, use the remaining screws to fully secure it to the frame. Ensure the fabric is taut and wrinkle-free.
Finishing Up




















With the new fabric installed, there's just one more step to complete the job:
- Test your awning to make sure it's working properly. Extend it fully, then retract it. If everything is working as it should, you're done!
Replacing the fabric on your Sunsetter awning might seem like a daunting task, but with the right tools and a bit of patience, it's a job you can do yourself. Enjoy your newly shaded outdoor space!